Specification sheet Wheel Loader Ref komatsu-wa270pt-3-active-wheel-loader
Komatsu WA270PT-3 Active
The Komatsu WA270PT-3 Active is a wheel loader with an operating weight of 27,998.71 lb (12,700 kg), a 141 hp engine, and a 2.62 yd³ (2 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
27,998.71lb
12,700kg
Engine power
141hp
105.15kW
Gross Power Bucket capacity
2.62yd³
2m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Komatsu WA270PT-3 Active sits below the median for its class:
- Operating weight 28,000 lb lighter than 66% (n=439)
- Engine power 141 hp less powerful than 73% (n=408)
- Bucket capacity 2.6 yd³ smaller-bucket than 76% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2238 | |
| Engine Model | S6D102 E1 | |
| Gross Power | 141hp | 105.2kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 417.5lb ft | 566Nm |
| Displacement | 360.1cu in | 5.9L |
| Aspiration | Turbocharged |
02 Operational Specification
| Operating Weight | 27998.8lb | 12700kg |
|---|---|---|
| Fuel Capacity | 48.9gal | 185L |
| Hydraulic System Fluid Capacity | 31.8gal | 120L |
| Engine Oil Fluid Capacity | 4.3gal | 16L |
| Cooling System Fluid Capacity | 14.8gal | 56L |
| Transmission Fluid Capacity | 4.5gal | 16.7L |
| Front Axle/Diff Fluid Capacity | 6.8gal | 25.5L |
| Rear Axle/Diff Fluid Capacity | 6.8gal | 25.5L |
| Static Tipping Weight | 18078lb | 8200kg |
| Turning Radius | 17.2ft in | 5240mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 50amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 20.5 R 25 |
03 Transmission Specification
| Transmission Type | fully automatic 4-speed full powershift with 'kickdown' | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 25mph | 40.2km/h |
| Max Speed - Reverse | 16.2mph | 26km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3045.8psi | 21000kPa |
|---|---|---|
| Pump Flow Capacity | 46.3gal/min | 175L/min |
| Raise Time | 5sec | |
| Dump Time | 1.5sec | |
| Lower Time | 2.7sec |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 8.29ft in | 2525mm |
|---|---|---|
| Bucket Capacity - Heaped | 2.62yd3 | 2m3 |
| Bucket Width | 8.21ft in | 2500mm |
| Breakout Force | 21581.66lb | 96kN |
06 Dimensions Dimensions
| Ground Clearance | 1.51ft in | 460mm |
|---|---|---|
| Length With Bucket On Ground | 23.79ft in | 7250mm |
| Width Over Tires | 8.01ft in | 2440mm |
| Height To Top Of Cab | 10.67ft in | 3250mm |
| Wheelbase | 9.52ft in | 2900mm |
| Hinge Pin - Max Height | 12.6ft in | 3838mm |
| Reach At Max Lift And Dump | 4.35ft in | 1324mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.