Specification sheet Wheel Loader Ref komatsu-wa250-3pt-wheel-loader
Komatsu WA250-3PT
The Komatsu WA250-3PT is a wheel loader with an operating weight of 25,165.77 lb (11,415 kg), a 130.08 hp engine, and a 2.49 yd³ (1.9 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
25,165.77lb
11,415kg
Engine power
130.08hp
97kW
Gross Power Bucket capacity
2.49yd³
1.9m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Komatsu WA250-3PT sits below the median for its class:
- Operating weight 25,170 lb lighter than 83% (n=439)
- Engine power 130 hp less powerful than 82% (n=408)
- Bucket capacity 2.5 yd³ smaller-bucket than 85% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2238 | |
| Engine Model | S6D102E-1 | |
| Gross Power | 130.1hp | 97kw |
| Power Measured @ | 2400rpm | |
| Displacement | 359cu in | 5.9L |
02 Operational Specification
| Operating Weight | 25165.8lb | 11415kg |
|---|---|---|
| Fuel Capacity | 48.7gal | 184L |
| Static Tipping Weight | 19025.9lb | 8630kg |
| Tire Size | 17.5-25-12PR |
03 Transmission Specification
| Number Of Forward Gears | 4 | |
|---|---|---|
| Number Of Reverse Gears | 4 | |
| Max Speed - Forward | 23.7mph | 38km/h |
| Max Speed - Reverse | 24.3mph | 39km/h |
04 Bucket Dimensions
| Dump Clearance At Max Raise | 9.16ft in | 2790mm |
|---|---|---|
| Bucket Capacity - Heaped | 2.49yd3 | 1.9m3 |
| Bucket Width | 8.81ft in | 2685mm |
| Breakout Force | 26983lb | 120.03kN |
05 Dimensions Dimensions
| Ground Clearance | 1.3ft in | 395mm |
|---|---|---|
| Length With Bucket On Ground | 23.79ft in | 7249mm |
| Width Over Tires | 7.55ft in | 2300mm |
| Height To Top Of Cab | 10.49ft in | 3195mm |
| Wheelbase | 9.52ft in | 2900mm |
| Hinge Pin - Max Height | 12.49ft in | 3805mm |
| Reach At Max Lift And Dump | 3.48ft in | 1060mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.