Specification sheet Wheel Loader Ref komatsu-w120-3-wheel-loader

Komatsu W120-3

The Komatsu W120-3 is a wheel loader with an operating weight of 37,787.24 lb (17,140 kg), a 200 hp engine, and a 4.32 yd³ (3.3 m³) bucket.

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
37,787.24lb
17,140kg
Engine power
200hp
149.14kW
Gross Power
Bucket capacity
4.32yd³
3.3m³

Where it sits in its classpercentile · small wheel loaders

Among 439 small wheel loaders (22,000–45,000 lb), the Komatsu W120-3 sits above the median for its class:

  • Operating weight 37,790 lb heavier than 76% (n=439)
  • Engine power 200 hp more powerful than 78% (n=408)
  • Bucket capacity 4.3 yd³ larger-bucket than 87% (n=387)

Scale drawingdrawn to scale · mm

3375B460C7640A
Side elevation
3375B2780D
Front elevation

01 Engine Specification

Engine Make 2238
Engine Model SA6D110
Gross Power 200hp 149.2kw
Displacement 435cu in 7.2L
Aspiration turbocharged

02 Operational Specification

Operating Weight 37787.3lb 17140kg
Fuel Capacity 80.1gal 303L
Cooling System Fluid Capacity 13gal 49L
Static Tipping Weight 28990.8lb 13150kg
Turning Radius 22.8ft in 6920mm
Tire Size 23.5-25-12PR (L-2)

03 Transmission Specification

Transmission Type TORQFLOW full power shift countershaft full soft-shift
Number Of Forward Gears 3
Number Of Reverse Gears 3
Max Speed - Forward 18.7mph 30km/h
Max Speed - Reverse 20.1mph 32.2km/h

04 Hydraulic System Specification

Raise Time 6.3sec
Dump Time 2.3sec
Lower Time 3.2sec

05 Bucket Dimensions

Dump Clearance At Max Raise 9.83ft in 2995mm
Bucket Capacity - Heaped 4.32yd3 3.3m3
Bucket Width 9.6ft in 2925mm
Breakout Force 31530lb 140.1kN

06 Dimensions Dimensions

Ground Clearance 1.51ft in 460mm
Length With Bucket On Ground 25.07ft in 7640mm
Width Over Tires 9.13ft in 2780mm
Height To Top Of Cab 11.08ft in 3375mm
Wheelbase 10.26ft in 3125mm
Hinge Pin - Max Height 13.23ft in 4030mm
Reach At Max Lift And Dump 4.04ft in 1230mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.