Specification sheet Skid Steer Loader Ref komatsu-sk05j-2-skid-steer-loader

Komatsu SK05J-2

The Komatsu SK05J-2 is a skid steer loader with an operating weight of 3,880.14 lb (1,760 kg), a 30.85 hp engine, a rated operating capacity of 956.81 lb (434 kg), and a tipping load of 1,874 lb (850.03 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
3,880.14lb
1,760kg
Engine power
30.85hp
23kW
Net Power
Rated operating capacity
956.81lb
434kg
Tipping load
1,874lb † — value reconstructed from related published figures
850.03kg
Bucket capacity
0.1yd³
0.1m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Komatsu SK05J-2 sits at the compact end of its class:

  • Operating weight 3,880 lb lighter than 92% (n=334)
  • Engine power 31 hp less powerful than 93% (n=335)
  • Rated operating capacity 960 lb lower-rated than 93% (n=288)

◇Scale drawingdrawn to scale · mm

1870B195C2760A
Side elevation
1870B1214D
Front elevation

01 Engine Specification

Number Of Cylinders 3
Engine Make 2238
Engine Model 3D84E-1FC
Gross Power 36hp 26.9kw
Net Power 30.9hp 23kw
Power Measured @ 2800rpm
Displacement 87.3cu in 1.5L

02 Operational Specification

Operational Weight 3880.2lb 1760kg
Fuel Capacity 12.7gal 48L
Engine Oil Fluid Capacity 2gal 7.5L
Max Speed 5.8mph 9.2km/h
Hydraulic System Fluid Capacity 4gal 15L
Tire Size 27- 8.50 x 15
Operating Voltage 12V
Alternator Supplied Amperage 40amps

03 Loader Specification

Breakout Force 2786.7lb 1264kg
Operating Load Rating 956.9lb 434kg
Bucket Capacity 0.1yd3 0.1m3

04 Hydraulic Specification

Pump Type gear pump
Pump Flow Capacity 8.5gal/min 32L/min
Relief Valve Pressure 2030.6psi 14000kPa

05 Dimensions Dimensions

Length With Bucket 9.06ft in 2760mm
Width Over Tires 3.99ft in 1214mm
Ground Clearance 7.68in 195mm
Height To Top Of Cab 6.14ft in 1870mm
Wheelbase 2.63ft in 800mm
Clearance At Max Lift And Dump 7.09ft in 2160mm
Reach At Max Lift And Dump 18.12in 460mm
Turning Radius From Center - Machine Rear 53.47in 1358mm
Turning Radius From Center - Inc Bucket 63.67in 1617mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.