Komatsu PC12UU-2 Specifications

Operating weight

4,409.3lb

Dig depth

7.22ft

◆Where it sits in its classpercentile · mini excavators

Among 479 mini excavators , the Komatsu PC12UU-2 sits below the median for its class:

Operating weight 4,410 lb lighter than 71% (n=438)
Dig depth 7.2 ft shallower-digging than 84% (n=426)

Not positioned on engine power — withheld or unpublished for this machine.

01 Boom/Stick Option (Hex) 1 Specification

Max Cutting Height	15.1ft in	4,602mm‖ — metric converted from the published imperial value
Max Reach Along Ground	12.6ft in	3,840mm‖ — metric converted from the published imperial value
Max Digging Depth	7.22ft in	2,201mm‖ — metric converted from the published imperial value

02 Dimensions Specification

Width To Outside Of Tracks	4.4ft in	1,341mm‖ — metric converted from the published imperial value
Length Of Track On Ground	11.95ft in	3,642mm‖ — metric converted from the published imperial value
Height To Top Of Cab	7.39ft in	2,252mm‖ — metric converted from the published imperial value
Tail Swing Radius	2.19ft in	668mm‖ — metric converted from the published imperial value

03 Undercarriage Specification

Max Travel Speed	1.25mph	2.01km/h‖ — metric converted from the published imperial value

04 Engine Specification

Engine Model	3D72
Power Measured @	2500rpm
Displacement	55cu in	901cm3‖ — metric converted from the published imperial value

05 Operational Specification

Operating Weight	4409.3lb	2,000kg‖ — metric converted from the published imperial value
Fuel Capacity	5.3gal	20l‖ — metric converted from the published imperial value
Hydraulic System Fluid Capacity	5.3gal	20l‖ — metric converted from the published imperial value

06 Swing Mechanism Specification

Swing Speed	9rpm

07 Buckets Specification

Reference Bucket Capacity	0.1yd3

Data notes

‖

Converted metric figure. The source published imperial figures only for this machine. Metric figures marked ‖ are unit conversions of the published imperial value, rounded to the same precision — they are not separately published measurements. Because there is no independently published metric figure to compare against, no cross-unit consistency check applies to them; the imperial figures they derive from were checked for physically possible magnitude and for plausibility against this equipment class.

Method. Figures are manufacturer reference specifications, not measurements. The source published imperial figures for this machine in a single unit system, so no cross-unit consistency check applies; every value is checked for physically possible magnitude and for plausibility against its equipment class before publication. Figures that fail either check are withheld rather than shown, and figures reconstructed from related data are marked above. Metric figures marked ‖ are converted from the published imperial value rather than reproduced from the source.