Specification sheet Wheel Loader Ref kawasaki-70ziv-2-wheel-loader
Kawasaki 70ZIV-2
The Kawasaki 70ZIV-2 is a wheel loader with an operating weight of 28,748.28 lb (13,040 kg), a 160 hp engine, and a 3.27 yd³ (2.5 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
28,748.28lb
13,040kg
Engine power
160hp
119.4kW
Net Power Bucket capacity
3.27yd³
2.5m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Kawasaki 70ZIV-2 sits below the median for its class:
- Operating weight 28,750 lb lighter than 61% (n=439)
- Engine power 160 hp less powerful than 56% (n=408)
- Bucket capacity 3.3 yd³ larger-bucket than 51% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2347 | |
| Engine Model | B5.9-C | |
| Net Power | 160hp | 119.4kw |
| Power Measured @ | 2400rpm | |
| Max Torque | 490lb ft | 664.4Nm |
| Displacement | 359cu in | 5.9L |
| Torque Measured @ | 1500rpm | |
| Aspiration | turbocharged & after cooled |
02 Operational Specification
| Operating Weight | 28748.3lb | 13040kg |
|---|---|---|
| Fuel Capacity | 58.2gal | 220L |
| Hydraulic System Fluid Capacity | 35.7gal | 135L |
| Engine Oil Fluid Capacity | 5.9gal | 22L |
| Cooling System Fluid Capacity | 14.3gal | 54L |
| Transmission Fluid Capacity | 8gal | 30L |
| Front Axle/Diff Fluid Capacity | 12.7gal | 48L |
| Rear Axle/Diff Fluid Capacity | 13.5gal | 51L |
| Static Tipping Weight | 22024.2lb | 9990kg |
| Turning Radius | 19.9ft in | 6040mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 65amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 20.5x25-12PR (L-2) |
03 Transmission Specification
| Transmission Type | full powershift | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 4 | |
| Max Speed - Forward | 23mph | 37.1km/h |
| Max Speed - Reverse | 23mph | 37.1km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3000psi | 20684.3kPa |
|---|---|---|
| Pump Flow Capacity | 15.9gal/min | 60.2L/min |
| Raise Time | 6.2sec | |
| Dump Time | 1.2sec | |
| Lower Time | 3.1sec | |
| Pump Type | gear type |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 8.88ft in | 2705mm |
|---|---|---|
| Bucket Capacity - Heaped | 3.27yd3 | 2.5m3 |
| Bucket Capacity - Struck | 2.75yd3 | 2.1m3 |
| Bucket Width | 8.76ft in | 2670mm |
| Breakout Force | 27560lb | 122.6kN |
06 Dimensions Dimensions
| Ground Clearance | 1.33ft in | 405mm |
|---|---|---|
| Length With Bucket On Ground | 24.41ft in | 7440mm |
| Width Over Tires | 8.49ft in | 2585mm |
| Height To Top Of Cab | 10.95ft in | 3335mm |
| Wheelbase | 10.01ft in | 3050mm |
| Hinge Pin - Max Height | 12.41ft in | 3780mm |
| Reach At Max Lift And Dump | 3.66ft in | 1115mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.