Specification sheet Wheel Loader Ref kawasaki-60zv-2-wheel-loader
Kawasaki 60ZV-2
The Kawasaki 60ZV-2 is a wheel loader with an operating weight of 44,037.34 lb (19,975 kg), a 122 hp engine, and a 2.23 yd³ (1.7 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
44,037.34lb
19,975kg
Engine power
122hp
91kW
Net Power Bucket capacity
2.23yd³
1.7m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Kawasaki 60ZV-2 sits at the heavy end of its class:
- Operating weight 44,040 lb heavier than 98% (n=439)
- Engine power 122 hp less powerful than 89% (n=408)
- Bucket capacity 2.2 yd³ smaller-bucket than 91% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2347 | |
| Engine Model | QSB4.5 | |
| Net Power | 122hp | 91kw |
| Gross Power | 130hp | 97kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 369lb ft | 500.3Nm |
| Displacement | 272cu in | 4.5L |
| Torque Measured @ | 1500rpm | |
| Aspiration | Turbocharger with Intercooler |
02 Operational Specification
| Operating Weight | 44037.4lb | 19975kg |
|---|---|---|
| Fuel Capacity | 46.3gal | 175L |
| Hydraulic System Fluid Capacity | 26.5gal | 100L |
| Engine Oil Fluid Capacity | 2.7gal | 10L |
| Cooling System Fluid Capacity | 6.7gal | 25L |
| Transmission Fluid Capacity | 5.3gal | 20L |
| Front Axle/Diff Fluid Capacity | 5.3gal | 20L |
| Rear Axle/Diff Fluid Capacity | 5.3gal | 20L |
| Static Tipping Weight | 17416.6lb | 7900kg |
| Turning Radius | 17.8ft in | 5415mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 70amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 15.5x25-12PR |
03 Transmission Specification
| Transmission Type | Power shift | |
|---|---|---|
| Number Of Forward Gears | 3 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 20.6mph | 33km/h |
| Max Speed - Reverse | 20.6mph | 33km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3000psi | 20684.3kPa |
|---|---|---|
| Raise Time | 6sec | |
| Dump Time | 1.2sec | |
| Lower Time | 3sec |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 8.99ft in | 2740mm |
|---|---|---|
| Bucket Capacity - Struck | 1.97yd3 | 1.5m3 |
| Bucket Width | 8.04ft in | 2450mm |
| Bucket Capacity - Heaped | 2.23yd3 | 1.7m3 |
06 Dimensions Dimensions
| Ground Clearance | 1.33ft in | 405mm |
|---|---|---|
| Length With Bucket On Ground | 21.97ft in | 6695mm |
| Width Over Tires | 7.58ft in | 2310mm |
| Height To Top Of Cab | 10.22ft in | 3115mm |
| Wheelbase | 8.86ft in | 2700mm |
| Hinge Pin - Max Height | 11.72ft in | 3570mm |
| Reach At Max Lift And Dump | 3.32ft in | 1010mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.