Specification sheet Skid Steer Loader Ref john-deere-90-skid-steer-loader

John Deere 90

The John Deere 90 is a skid steer loader with an operating weight of 2,825 lb (1,281 kg), a 23 hp engine, a rated operating capacity of 700 lb (318 kg), and a tipping load of 1,400 lb (635.03 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
2,825lb
1,281kg
Engine power
23hp
17.16kW
Net Power
Rated operating capacity
700lb
318kg
Tipping load
1,400lb † — value reconstructed from related published figures
635.03kg
Bucket capacity
0.4yd³
0.3m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the John Deere 90 sits at the compact end of its class:

  • Operating weight 2,830 lb lighter than 96% (n=334)
  • Engine power 23 hp less powerful than 97% (n=335)
  • Rated operating capacity 700 lb lower-rated than 97% (n=288)

◇Scale drawingdrawn to scale · mm

1880C171D2591A2032B
Side elevation
1880C1156E
Front elevation

01 Engine Specification

Number Of Cylinders 2
Engine Make 2370
Net Power 23hp 17.2kw
Power Measured @ 3000rpm
Displacement 60cu in 1L

02 Operational Specification

Operational Weight 2825lb 1281kg
Fuel Capacity 7.2gal 27L
Hydraulic System Fluid Capacity 11gal 41.8L
Max Speed 5mph 8km/h
Operating Speed 5mph 8km/h
Tire Size 8.50-15
Operating Voltage 12V

03 Loader Specification

Operating Load Rating 700lb 318kg
Bucket Capacity 0.4yd3 0.3m3

04 Hydraulic Specification

Pump Type Open-center
Pump Flow Capacity 7.5gal/min 28.4L/min
Relief Valve Pressure 1750psi 12065.9kPa

05 Dimensions Dimensions

Length With Bucket 8.51ft in 2591mm
Width Over Tires 3.8ft in 1156mm
Ground Clearance 6.75in 171mm
Height To Top Of Cab 6.17ft in 1880mm
Wheelbase 2.57ft in 781mm
Length W/O Bucket 6.67ft in 2032mm
Clearance At Max Lift And Dump 6.09ft in 1854mm
Reach At Max Lift And Dump 125in 3175mm
Turning Radius From Center - Machine Rear 47in 1194mm
Turning Radius From Center - Inc Bucket 47in 1194mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.