Specification sheet Skid Steer Loader Ref john-deere-7775-skid-steer-loader
John Deere 7775
The John Deere 7775 is a skid steer loader with an operating weight of 5,405 lb (2,452 kg), a 49 hp engine, a rated operating capacity of 1,705 lb (773 kg), and a 0.6 yd³ (0.5 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
5,405lb
2,452kg
Engine power
49hp
36.54kW
Net Power Rated operating capacity
1,705lb
773kg
Bucket capacity
0.6yd³
0.5m³
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the John Deere 7775 sits below the median for its class:
- Operating weight 5,410 lb lighter than 81% (n=334)
- Engine power 49 hp less powerful than 75% (n=335)
- Rated operating capacity 1,710 lb lower-rated than 63% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2240 | |
| Engine Model | Series 220 | |
| Gross Power | 52hp | 38.8kw |
| Net Power | 49hp | 36.6kw |
| Power Measured @ | 3000rpm | |
| Displacement | 133.5cu in | 2.2L |
02 Operational Specification
| Operational Weight | 5405lb | 2452kg |
|---|---|---|
| Fuel Capacity | 14.4gal | 54.5L |
| Max Speed | 7.4mph | 11.9km/h |
| Operating Speed | 7.4mph | 11.9km/h |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 40amps |
03 Loader Specification
| Breakout Force | 3712lb | 1684kg |
|---|---|---|
| Operating Load Rating | 1705lb | 773kg |
| Bucket Capacity | 0.6yd3 | 0.5m3 |
04 Hydraulic Specification
| Pump Type | Open-center | |
|---|---|---|
| Relief Valve Pressure | 2650psi | 18271kPa |
05 Dimensions Dimensions
| Length With Bucket | 10.57ft in | 3220mm |
|---|---|---|
| Ground Clearance | 7.7in | 195.58mm |
| Height To Top Of Cab | 6.24ft in | 1900mm |
| Wheelbase | 3.55ft in | 1080mm |
| Length W/O Bucket | 8.47ft in | 2580mm |
| Clearance At Max Lift And Dump | 7.55ft in | 2300mm |
| Reach At Max Lift And Dump | 28in | 711.2mm |
| Turning Radius From Center - Inc Bucket | 45in | 1143mm |
| Turning Radius From Center - Machine Rear | 45in | 1143mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.