Specification sheet Wheel Loader Ref john-deere-624gh-wheel-loader
John Deere 624GH
The John Deere 624GH is a wheel loader with an operating weight of 27,435 lb (12,444.31 kg), a 150 hp engine, and a 3 yd³ (2.3 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
27,435lb
12,444.31kg
Engine power
150hp
112kW
Net Power Bucket capacity
3yd³
2.3m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the John Deere 624GH sits below the median for its class:
- Operating weight 27,440 lb lighter than 70% (n=439)
- Engine power 150 hp less powerful than 64% (n=408)
- Bucket capacity 3 yd³ smaller-bucket than 66% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2240 | |
| Engine Model | 6068T | |
| Net Power | 150hp | 112kw |
| Gross Power | 161hp | 120kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 455lb ft | 617Nm |
| Displacement | 414cu in | 6.8L |
| Torque Measured @ | 1350rpm | |
| Aspiration | Turbocharger |
02 Operational Specification
| Operating Weight | 27435lb | 12444.4kg |
|---|---|---|
| Fuel Capacity | 65.8gal | 249L |
| Hydraulic System Fluid Capacity | 27gal | 102L |
| Engine Oil Fluid Capacity | 5.1gal | 19L |
| Cooling System Fluid Capacity | 6.7gal | 25L |
| Transmission Fluid Capacity | 3gal | 11L |
| Front Axle/Diff Fluid Capacity | 7.4gal | 28L |
| Rear Axle/Diff Fluid Capacity | 5.1gal | 19L |
| Static Tipping Weight | 21205.1lb | 9618.5kg |
| Turning Radius | 16.9ft in | 5129.8mm |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 95amps | |
| Rear Axle Oscillation | 26degrees | |
| Tire Size | 17.5-25 |
03 Transmission Specification
| Transmission Type | Power Shift with Torque Converter | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 23mph | 37.3km/h |
| Max Speed - Reverse | 15.2mph | 24.5km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 2800psi | 19305.4kPa |
|---|---|---|
| Pump Flow Capacity | 61gal/min | 231L/min |
| Raise Time | 5.8sec | |
| Dump Time | 1.7sec | |
| Lower Time | 3.5sec | |
| Pump Type | Gear type , open -center system |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.41ft in | 2868mm |
|---|---|---|
| Bucket Capacity - Heaped | 3yd3 | 2.3m3 |
| Bucket Capacity - Struck | 2.63yd3 | 2m3 |
| Bucket Width | 8.47ft in | 2580mm |
| Breakout Force | 29404lb | 130.81kN |
06 Dimensions Dimensions
| Ground Clearance | 1.43ft in | 433mm |
|---|---|---|
| Length With Bucket On Ground | 24.32ft in | 7410mm |
| Width Over Tires | 8.37ft in | 2549mm |
| Height To Top Of Cab | 10.83ft in | 3300mm |
| Wheelbase | 9.95ft in | 3030mm |
| Hinge Pin - Max Height | 12.77ft in | 3890mm |
| Reach At Max Lift And Dump | 3.17ft in | 966mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.