Specification sheet Wheel Loader Ref john-deere-624e-w-coupler-wheel-loader
John Deere 624E w/ Coupler
The John Deere 624E w/ Coupler is a wheel loader with an operating weight of 27,661 lb (12,547 kg), a 135 hp engine, and a 2.25 yd³ (1.73 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
27,661lb
12,547kg
Engine power
135hp
100.7kW
Net Power Bucket capacity
2.25yd³
1.73m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the John Deere 624E w/ Coupler sits below the median for its class:
- Operating weight 27,660 lb lighter than 69% (n=439)
- Engine power 135 hp less powerful than 80% (n=408)
- Bucket capacity 2.3 yd³ smaller-bucket than 89% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2240 | |
| Engine Model | 6414T | |
| Net Power | 135hp | 100.7kw |
| Gross Power | 141hp | 105.2kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 420lb ft | 569.5Nm |
| Displacement | 414cu in | 6.8L |
| Torque Measured @ | 1300rpm | |
| Aspiration | Turbocharged |
02 Operational Specification
| Operating Weight | 27661lb | 12547kg |
|---|---|---|
| Fuel Capacity | 55gal | 208L |
| Hydraulic System Fluid Capacity | 27gal | 102L |
| Engine Oil Fluid Capacity | 5.1gal | 19L |
| Cooling System Fluid Capacity | 6.7gal | 25L |
| Transmission Fluid Capacity | 2.7gal | 10L |
| Front Axle/Diff Fluid Capacity | 6.1gal | 23L |
| Rear Axle/Diff Fluid Capacity | 4.3gal | 16L |
| Static Tipping Weight | 20915lb | 9487kg |
| Turning Radius | 16.8ft in | 5110mm |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 65amps | |
| Rear Axle Oscillation | 26degrees | |
| Tire Size | 17.5-25 |
03 Transmission Specification
| Transmission Type | Power Shift | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 25.4mph | 40.9km/h |
| Max Speed - Reverse | 16mph | 25.8km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 2800psi | 19305.4kPa |
|---|---|---|
| Pump Flow Capacity | 57gal/min | 215.8L/min |
| Raise Time | 5.8sec | |
| Dump Time | 1.7sec | |
| Lower Time | 3.5sec | |
| Pump Type | Gear |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.67ft in | 2945mm |
|---|---|---|
| Bucket Capacity - Heaped | 2.25yd3 | 1.73m3 |
| Bucket Capacity - Struck | 1.88yd3 | 1.44m3 |
| Bucket Width | 8.37ft in | 2550mm |
| Breakout Force | 30768lb | 136.9kN |
06 Dimensions Dimensions
| Length With Bucket On Ground | 24.09ft in | 7340mm |
|---|---|---|
| Width Over Tires | 8.17ft in | 2489mm |
| Height To Top Of Cab | 10.73ft in | 3270mm |
| Wheelbase | 9.95ft in | 3030mm |
| Hinge Pin - Max Height | 12.77ft in | 3890mm |
| Reach At Max Lift And Dump | 2.92ft in | 888mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.