Specification sheet Skid Steer Loader Ref john-deere-60-skid-steer-loader

John Deere 60

The John Deere 60 is a skid steer loader with an operating weight of 2,076 lb (942 kg), a 17 hp engine, a rated operating capacity of 600 lb (272 kg), and a tipping load of 1,200 lb (544.31 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
2,076lb
942kg
Engine power
17hp
12.68kW
Net Power
Rated operating capacity
600lb
272kg
Tipping load
1,200lb † — value reconstructed from related published figures
544.31kg
Bucket capacity
0.2yd³
0.2m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the John Deere 60 sits at the compact end of its class:

  • Operating weight 2,080 lb lighter than 99% (n=334)
  • Engine power 17 hp less powerful than 99% (n=335)
  • Rated operating capacity 600 lb lower-rated than 99% (n=288)

◇Scale drawingdrawn to scale · mm

1892B127C2432A
Side elevation
1892B902D
Front elevation

01 Engine Specification

Number Of Cylinders 2
Engine Make 2355
Engine Model KT17
Net Power 17hp 12.7kw
Power Measured @ 3400rpm
Displacement 42.2cu in 0.7L

02 Operational Specification

Operational Weight 2076lb 942kg
Fuel Capacity 5gal 18.9L
Max Speed 4.3mph 6.9km/h
Hydraulic System Fluid Capacity 18gal 68L
Operating Speed 4.3mph 6.9km/h
Tire Size 5.70-12
Operating Voltage 12V

03 Loader Specification

Operating Load Rating 600lb 272kg
Bucket Capacity 0.2yd3 0.2m3

04 Hydraulic Specification

Pump Type Open-center
Pump Flow Capacity 7.5gal/min 28.4L/min

05 Dimensions Dimensions

Length With Bucket 7.98ft in 2432mm
Width Over Tires 2.96ft in 902mm
Ground Clearance 5in 127mm
Height To Top Of Cab 6.21ft in 1892mm
Wheelbase 2.44ft in 741mm
Clearance At Max Lift And Dump 6.07ft in 1848mm
Reach At Max Lift And Dump 13.51in 343mm
Turning Radius From Center - Machine Rear 45.75in 1162mm
Turning Radius From Center - Inc Bucket 45.75in 1162mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.