Specification sheet Skid Steer Loader Ref john-deere-5575-skid-steer-loader

John Deere 5575

The John Deere 5575 is a skid steer loader with an operating weight of 4,500 lb (2,045.3 kg), a 37 hp engine, a rated operating capacity of 1,410 lb (640 kg), and a tipping load of 2,819.8 lb (1,279.04 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
4,500lb
2,045.3kg
Engine power
37hp
27.6kW
Net Power
Rated operating capacity
1,410lb
640kg
Tipping load
2,819.8lb † — value reconstructed from related published figures
1,279.04kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the John Deere 5575 sits at the compact end of its class:

  • Operating weight 4,500 lb lighter than 90% (n=334)
  • Engine power 37 hp less powerful than 90% (n=335)
  • Rated operating capacity 1,410 lb lower-rated than 79% (n=288)

◇Scale drawingdrawn to scale · mm

1839C210D3048A2446B
Side elevation
1839C1523E
Front elevation

01 Engine Specification

Number Of Cylinders 3
Engine Make 2240
Engine Model 3017D001
Gross Power 39hp 29.1kw
Net Power 37hp 27.6kw
Power Measured @ 3000rpm
Displacement 100.1cu in 1.7L

02 Operational Specification

Operational Weight 4500lb 2045.3kg
Fuel Capacity 10gal 37.8L
Cooling System Fluid Capacity 2.8gal 10.3L
Max Speed 6.7mph 10.8km/h
Chain Box Fluid Capacity - Each Side 1.6gal 5.7L
Operating Speed 6.7mph 10.8km/h
Operating Voltage 12V
Alternator Supplied Amperage 40amps

03 Loader Specification

Operating Load Rating 1410lb 640kg

04 Hydraulic Specification

Pump Type Gear
Pump Flow Capacity 10gal/min 37.8L/min
Relief Valve Pressure 2650psi 18271kPa

05 Dimensions Dimensions

Length With Bucket 10ft in 3048mm
Width Over Tires 5ft in 1523mm
Ground Clearance 8.25in 210mm
Height To Top Of Cab 6.04ft in 1839mm
Wheelbase 3.12ft in 950mm
Length W/O Bucket 8.03ft in 2446mm
Clearance At Max Lift And Dump 7.33ft in 2233mm
Turning Radius From Center - Machine Rear 56in 1422mm
Turning Radius From Center - Inc Bucket 71in 1803mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.