Specification sheet Wheel Loader Ref john-deere-544k-z-bar-wheel-loader
John Deere 544K Z-Bar
The John Deere 544K Z-Bar is a wheel loader with an operating weight of 28,263.27 lb (12,820 kg), a 167 hp engine, and a 3.01 yd³ (2.3 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
28,263.27lb
12,820kg
Engine power
167hp
124.6kW
Net Power Bucket capacity
3.01yd³
2.3m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the John Deere 544K Z-Bar sits below the median for its class:
- Operating weight 28,260 lb lighter than 64% (n=439)
- Engine power 167 hp more powerful than 52% (n=408)
- Bucket capacity 3 yd³ smaller-bucket than 60% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2240 | |
| Engine Model | E 6068H, Tier III certified | |
| Net Power | 167hp | 124.6kw |
| Power Measured @ | 1900rpm | |
| Max Torque | 496lb ft | 672.5Nm |
| Displacement | 414cu in | 6.8L |
| Torque Measured @ | 1600rpm | |
| Aspiration | Turbocharged charge air cooled | |
| Torque Rise | 38% |
02 Operational Specification
| Operating Weight | 28263.3lb | 12820kg |
|---|---|---|
| Fuel Capacity | 85.9gal | 325L |
| Hydraulic System Fluid Capacity | 24.1gal | 91L |
| Engine Oil Fluid Capacity | 5.1gal | 19L |
| Cooling System Fluid Capacity | 6.1gal | 23L |
| Transmission Fluid Capacity | 4.9gal | 18.5L |
| Front Axle/Diff Fluid Capacity | 4.5gal | 17L |
| Rear Axle/Diff Fluid Capacity | 4.5gal | 17L |
| Static Tipping Weight | 24021.6lb | 10896kg |
| Turning Radius | 16.5ft in | 5000mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 80amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 20.5 R 25 |
03 Transmission Specification
| Transmission Type | Countershaft, powershift | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 22.2mph | 35.7km/h |
| Max Speed - Reverse | 15mph | 24.1km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3650psi | 25165.9kPa |
|---|---|---|
| Pump Flow Capacity | 50gal/min | 189L/min |
| Raise Time | 5.8sec | |
| Dump Time | 1.2sec | |
| Lower Time | 3.2sec | |
| Pump Type | variable displacement, axial piston |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.06ft in | 2760mm |
|---|---|---|
| Bucket Capacity - Heaped | 3.01yd3 | 2.3m3 |
| Bucket Capacity - Struck | 2.62yd3 | 2m3 |
| Bucket Width | 8.34ft in | 2540mm |
| Breakout Force | 22672lb | 100.86kN |
06 Dimensions Dimensions
| Ground Clearance | 1.32ft in | 400mm |
|---|---|---|
| Length With Bucket On Ground | 24.38ft in | 7430mm |
| Width Over Tires | 8.36ft in | 2546mm |
| Height To Top Of Cab | 10.63ft in | 3240mm |
| Wheelbase | 9.62ft in | 2930mm |
| Hinge Pin - Max Height | 12.54ft in | 3820mm |
| Reach At Max Lift And Dump | 3.25ft in | 990mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.