Specification sheet Wheel Loader Ref john-deere-524k-high-lift-wheel-loader
John Deere 524K High-Lift
The John Deere 524K High-Lift is a wheel loader with an operating weight of 27,500.47 lb (12,474 kg), a 146 hp engine, and a 2.75 yd³ (2.1 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
27,500.47lb
12,474kg
Engine power
146hp
108.9kW
Net Power Bucket capacity
2.75yd³
2.1m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the John Deere 524K High-Lift sits below the median for its class:
- Operating weight 27,500 lb lighter than 70% (n=439)
- Engine power 146 hp less powerful than 68% (n=408)
- Bucket capacity 2.8 yd³ smaller-bucket than 70% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2240 | |
| Engine Model | E 6068H, Tier III certified | |
| Net Power | 146hp | 108.9kw |
| Power Measured @ | 2000rpm | |
| Max Torque | 448lb ft | 607.5Nm |
| Displacement | 414cu in | 6.8L |
| Torque Measured @ | 1600rpm | |
| Aspiration | Turbocharged charge air cooled | |
| Torque Rise | 47% |
02 Operational Specification
| Operating Weight | 27500.5lb | 12474kg |
|---|---|---|
| Fuel Capacity | 85.9gal | 325L |
| Hydraulic System Fluid Capacity | 24.1gal | 91L |
| Engine Oil Fluid Capacity | 5.1gal | 19L |
| Cooling System Fluid Capacity | 6.1gal | 23L |
| Transmission Fluid Capacity | 4.9gal | 18.5L |
| Front Axle/Diff Fluid Capacity | 4.5gal | 17L |
| Rear Axle/Diff Fluid Capacity | 4.5gal | 17L |
| Static Tipping Weight | 19290.5lb | 8750kg |
| Turning Radius | 16.5ft in | 5000mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 80amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 20.5 R 25 |
03 Transmission Specification
| Transmission Type | Countershaft, powershift | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 22.4mph | 36km/h |
| Max Speed - Reverse | 15mph | 24.1km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3625psi | 24993.5kPa |
|---|---|---|
| Pump Flow Capacity | 43.6gal/min | 165L/min |
| Raise Time | 6.1sec | |
| Dump Time | 1.4sec | |
| Lower Time | 3sec | |
| Pump Type | variable displacement, axial piston |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 10.24ft in | 3120mm |
|---|---|---|
| Bucket Capacity - Heaped | 2.75yd3 | 2.1m3 |
| Bucket Capacity - Struck | 2.23yd3 | 1.7m3 |
| Bucket Width | 8.34ft in | 2540mm |
| Breakout Force | 22394lb | 99.62kN |
06 Dimensions Dimensions
| Ground Clearance | 1.32ft in | 400mm |
|---|---|---|
| Length With Bucket On Ground | 25.17ft in | 7670mm |
| Width Over Tires | 8.35ft in | 2545mm |
| Height To Top Of Cab | 10.67ft in | 3250mm |
| Wheelbase | 9.62ft in | 2930mm |
| Hinge Pin - Max Height | 13.52ft in | 4120mm |
| Reach At Max Lift And Dump | 3.25ft in | 990mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.