Specification sheet Skid Steer Loader Ref john-deere-4475-skid-steer-loader
John Deere 4475
The John Deere 4475 is a skid steer loader with an operating weight of 4,360 lb (1,977.67 kg), a 31 hp engine, a rated operating capacity of 1,250 lb (567 kg), and a 0.5 yd³ (0.4 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
4,360lb
1,977.67kg
Engine power
31hp
23.12kW
Net Power Rated operating capacity
1,250lb
567kg
Bucket capacity
0.5yd³
0.4m³
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the John Deere 4475 sits at the compact end of its class:
- Operating weight 4,360 lb lighter than 91% (n=334)
- Engine power 31 hp less powerful than 93% (n=335)
- Rated operating capacity 1,250 lb lower-rated than 90% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2240 | |
| Engine Model | Series 220 | |
| Gross Power | 32hp | 23.9kw |
| Net Power | 31hp | 23.2kw |
| Power Measured @ | 3000rpm | |
| Displacement | 91.3cu in | 1.5L |
02 Operational Specification
| Operational Weight | 4360lb | 1977.7kg |
|---|---|---|
| Fuel Capacity | 12gal | 45.4L |
| Max Speed | 6.5mph | 10.4km/h |
| Operating Speed | 6.5mph | 10.4km/h |
| Operating Voltage | 12V |
03 Loader Specification
| Breakout Force | 2600lb | 1179kg |
|---|---|---|
| Operating Load Rating | 1250lb | 567kg |
| Bucket Capacity | 0.5yd3 | 0.4m3 |
04 Hydraulic Specification
| Pump Type | Open-center | |
|---|---|---|
| Pump Flow Capacity | 11gal/min | 41.7L/min |
| Relief Valve Pressure | 2650psi | 18271kPa |
05 Dimensions Dimensions
| Length With Bucket | 10.01ft in | 3050mm |
|---|---|---|
| Ground Clearance | 8.27in | 210mm |
| Height To Top Of Cab | 6.04ft in | 1840mm |
| Wheelbase | 31.17ft in | 9500mm |
| Length W/O Bucket | 8.04ft in | 2450mm |
| Clearance At Max Lift And Dump | 7.32ft in | 2230mm |
| Reach At Max Lift And Dump | 20.25in | 514.35mm |
| Turning Radius From Center - Machine Rear | 45in | 1143mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.