Specification sheet Skid Steer Loader Ref john-deere-332-skid-steer-loader

John Deere 332

The John Deere 332 is a skid steer loader with an operating weight of 9,160 lb (4,154.91 kg), a 85 hp engine, a rated operating capacity of 3,175 lb (1,440.16 kg), and a tipping load of 6,350 lb (2,880.31 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
9,160lb
4,154.91kg
Engine power
85hp
63.39kW
Net Power
Rated operating capacity
3,175lb
1,440.16kg
Tipping load
6,350lb † — value reconstructed from related published figures
2,880.31kg
Bucket capacity
0.7yd³
0.5m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the John Deere 332 sits at the heavy end of its class:

  • Operating weight 9,160 lb heavier than 94% (n=334)
  • Engine power 85 hp more powerful than 91% (n=335)
  • Rated operating capacity 3,180 lb higher-rated than 94% (n=288)

◇Scale drawingdrawn to scale · mm

2106C241D3518A2934B
Side elevation
2106C1958E
Front elevation

01 Engine Specification

Number Of Cylinders 5
Engine Make 2240
Engine Model 5030HW
Gross Power 91hp 67.9kw
Net Power 85hp 63.4kw
Power Measured @ 2800rpm
Aspiration turbocharged
Displacement 186cu in 3.1L

02 Operational Specification

Operational Weight 9160lb 4155kg
Fuel Capacity 24gal 90.9L
Max Speed 11.2mph 18km/h
Tire Size 14x17.5 14 PR
Operating Voltage 12V
Alternator Supplied Amperage 70amps

03 Loader Specification

Breakout Force 11600lb 5261.7kg
Operating Load Rating 3175lb 1440.2kg
Bucket Capacity 0.7yd3 0.5m3

04 Hydraulic Specification

Pump Flow Capacity 24.1gal/min 91L/min
Relief Valve Pressure 3100psi 21373.8kPa

05 Dimensions Dimensions

Length With Bucket 11.55ft in 3518mm
Width Over Tires 6.43ft in 1958mm
Ground Clearance 9.49in 241mm
Height To Top Of Cab 6.91ft in 2106mm
Wheelbase 4.05ft in 1234mm
Length W/O Bucket 9.63ft in 2934mm
Clearance At Max Lift And Dump 8.51ft in 2591mm
Reach At Max Lift And Dump 32.01in 813mm
Turning Radius From Center - Inc Bucket 83.71in 2126mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.