Specification sheet Skid Steer Loader Ref john-deere-328-skid-steer-loader

John Deere 328

The John Deere 328 is a skid steer loader with an operating weight of 8,580 lb (3,891.83 kg), a 76 hp engine, a rated operating capacity of 2,750 lb (1,247.38 kg), and a tipping load of 5,500 lb (2,494.76 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
8,580lb
3,891.83kg
Engine power
76hp
56.68kW
Net Power
Rated operating capacity
2,750lb
1,247.38kg
Tipping load
5,500lb † — value reconstructed from related published figures
2,494.76kg
Bucket capacity
0.7yd³
0.5m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the John Deere 328 sits at the heavy end of its class:

  • Operating weight 8,580 lb heavier than 89% (n=334)
  • Engine power 76 hp more powerful than 76% (n=335)
  • Rated operating capacity 2,750 lb higher-rated than 87% (n=288)

◇Scale drawingdrawn to scale · mm

2106C279D3518A2934B
Side elevation
2106C1933E
Front elevation

01 Engine Specification

Number Of Cylinders 5
Engine Make 2240
Engine Model 5030TW
Gross Power 82hp 61.2kw
Net Power 76hp 56.7kw
Power Measured @ 2800rpm
Aspiration Turbocharged
Displacement 186cu in 3.1L

02 Operational Specification

Operational Weight 8580lb 3891.9kg
Fuel Capacity 24gal 90.9L
Max Speed 12mph 19.3km/h
Tire Size 14x17.5 12PR
Operating Voltage 12V
Alternator Supplied Amperage 70amps

03 Loader Specification

Breakout Force 10500lb 4762.8kg
Operating Load Rating 2750lb 1247.4kg
Bucket Capacity 0.7yd3 0.5m3

04 Hydraulic Specification

Pump Flow Capacity 22gal/min 83L/min
Relief Valve Pressure 3100psi 21373.8kPa

05 Dimensions Dimensions

Length With Bucket 11.55ft in 3518mm
Width Over Tires 6.35ft in 1933mm
Ground Clearance 10.99in 279mm
Height To Top Of Cab 6.91ft in 2106mm
Wheelbase 3.97ft in 1209mm
Length W/O Bucket 9.63ft in 2934mm
Clearance At Max Lift And Dump 8.51ft in 2591mm
Reach At Max Lift And Dump 32.01in 813mm
Turning Radius From Center - Inc Bucket 83.71in 2126mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.