Specification sheet Skid Steer Loader Ref john-deere-325-skid-steer-loader

John Deere 325

The John Deere 325 is a skid steer loader with an operating weight of 8,390 lb (3,806 kg), a 70 hp engine, a rated operating capacity of 2,500 lb (1,133.99 kg), and a tipping load of 5,000 lb (2,267.96 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
8,390lb
3,806kg
Engine power
70hp
52.2kW
Net Power
Rated operating capacity
2,500lb
1,133.99kg
Tipping load
5,000lb † — value reconstructed from related published figures
2,267.96kg
Bucket capacity
0.7yd³
0.5m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the John Deere 325 sits at the heavy end of its class:

  • Operating weight 8,390 lb heavier than 87% (n=334)
  • Engine power 70 hp more powerful than 59% (n=335)
  • Rated operating capacity 2,500 lb higher-rated than 77% (n=288)

◇Scale drawingdrawn to scale · mm

2055C229D3518A2934B
Side elevation
2055C1872E
Front elevation

01 Engine Specification

Number Of Cylinders 5
Engine Make 2240
Engine Model 5030T
Gross Power 76hp 56.7kw
Net Power 70hp 52.2kw
Power Measured @ 2800rpm
Aspiration Turbocharged
Displacement 186cu in 3.1L

02 Operational Specification

Operational Weight 8390lb 3806kg
Fuel Capacity 24.1gal 91L
Max Speed 11mph 17.7km/h
Tire Size 12x16.5 8 PR SKS
Operating Voltage 12V
Alternator Supplied Amperage 70amps

03 Loader Specification

Breakout Force 7500lb 3402kg
Operating Load Rating 2500lb 1134kg
Bucket Capacity 0.7yd3 0.5m3

04 Hydraulic Specification

Pump Flow Capacity 22gal/min 83L/min
Relief Valve Pressure 3100psi 21373.8kPa

05 Dimensions Dimensions

Length With Bucket 11.55ft in 3518mm
Width Over Tires 6.15ft in 1872mm
Ground Clearance 9in 229mm
Height To Top Of Cab 6.75ft in 2055mm
Wheelbase 3.97ft in 1209mm
Length W/O Bucket 9.63ft in 2934mm
Clearance At Max Lift And Dump 8.34ft in 2540mm
Reach At Max Lift And Dump 34.02in 864mm
Turning Radius From Center - Inc Bucket 83.71in 2126mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.