Specification sheet Skid Steer Loader Ref john-deere-317-skid-steer-loader

John Deere 317

The John Deere 317 is a skid steer loader with an operating weight of 6,300 lb (2,857.64 kg), a 57 hp engine, a rated operating capacity of 1,750 lb (793.79 kg), and a tipping load of 3,700 lb (1,678.29 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,300lb
2,857.64kg
Engine power
57hp
42.51kW
Net Power
Rated operating capacity
1,750lb
793.79kg
Tipping load
3,700lb † — value reconstructed from related published figures
1,678.29kg
Bucket capacity
0.6yd³
0.5m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the John Deere 317 sits below the median for its class:

  • Operating weight 6,300 lb lighter than 61% (n=334)
  • Engine power 57 hp less powerful than 61% (n=335)
  • Rated operating capacity 1,750 lb lower-rated than 61% (n=288)

◇Scale drawingdrawn to scale · mm

1915C208D3195A2591B
Side elevation
1915C1628E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2240
Engine Model 4042T
Gross Power 61hp 45.5kw
Net Power 57hp 42.6kw
Power Measured @ 2800rpm
Aspiration Turbocharged
Displacement 149cu in 2.5L

02 Operational Specification

Operational Weight 6300lb 2857.7kg
Fuel Capacity 16gal 60.6L
Max Speed 6.8mph 11km/h
Tire Size 10x16.5 8PR
Operating Voltage 12V
Alternator Supplied Amperage 70amps

03 Loader Specification

Breakout Force 5500lb 2494.8kg
Operating Load Rating 1750lb 793.8kg
Bucket Capacity 0.6yd3 0.5m3

04 Hydraulic Specification

Pump Flow Capacity 17gal/min 64L/min
Relief Valve Pressure 3450psi 23786.9kPa

05 Dimensions Dimensions

Length With Bucket 10.49ft in 3195mm
Width Over Tires 5.35ft in 1628mm
Ground Clearance 8.19in 208mm
Height To Top Of Cab 6.29ft in 1915mm
Wheelbase 3.53ft in 1074mm
Length W/O Bucket 8.51ft in 2591mm
Clearance At Max Lift And Dump 7.4ft in 2255mm
Reach At Max Lift And Dump 29.1in 739mm
Turning Radius From Center - Inc Bucket 78.9in 2004mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.