Specification sheet Skid Steer Loader Ref john-deere-270-skid-steer-loader

John Deere 270

The John Deere 270 is a skid steer loader with an operating weight of 8,500 lb (3,856 kg), a 77 hp engine, a rated operating capacity of 2,800 lb (1,270 kg), and a tipping load of 5,600 lb (2,540.12 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
8,500lb
3,856kg
Engine power
77hp
57.5kW
Net Power
Rated operating capacity
2,800lb
1,270kg
Tipping load
5,600lb † — value reconstructed from related published figures
2,540.12kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the John Deere 270 sits at the heavy end of its class:

  • Operating weight 8,500 lb heavier than 89% (n=334)
  • Engine power 77 hp more powerful than 79% (n=335)
  • Rated operating capacity 2,800 lb higher-rated than 88% (n=288)

◇Scale drawingdrawn to scale · mm

2105C280D3504A2921B
Side elevation
2105C1935E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2240
Engine Model 4045D
Gross Power 82hp 60.4kw
Net Power 77hp 57.5kw
Power Measured @ 2400rpm
Displacement 275cu in 4.5L

02 Operational Specification

Operational Weight 8500lb 3856kg
Fuel Capacity 20gal 76L
Cooling System Fluid Capacity 3.6gal 13.4L
Hydraulic System Fluid Capacity 9gal 34.1L
Max Speed 12mph 19.3km/h
Operating Speed 7mph 11.3km/h
Tire Size 14x17.5 SKS Extra-Wall,12PR
Operating Voltage 12V
Alternator Supplied Amperage 55amps

03 Loader Specification

Breakout Force 10500lb 4762.8kg
Operating Load Rating 2800lb 1270kg

04 Hydraulic Specification

Pump Type 3-spool open center
Pump Flow Capacity 21.3gal/min 80.6L/min
Relief Valve Pressure 3100psi 21374kPa

05 Dimensions Dimensions

Length With Bucket 11.5ft in 3504mm
Width Over Tires 6.35ft in 1935mm
Ground Clearance 11in 280mm
Height To Top Of Cab 6.91ft in 2105mm
Wheelbase 3.97ft in 1209mm
Length W/O Bucket 9.59ft in 2921mm
Clearance At Max Lift And Dump 8.51ft in 2591mm
Reach At Max Lift And Dump 32in 813mm
Turning Radius From Center - Machine Rear 69in 1752mm
Turning Radius From Center - Inc Bucket 83.7in 2126mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.