Specification sheet Skid Steer Loader Ref john-deere-250-series-ii-skid-steer-loader

John Deere 250 Series II

The John Deere 250 Series II is a skid steer loader with an operating weight of 6,250 lb (2,834.96 kg), a 61 hp engine, a rated operating capacity of 1,750 lb (793.79 kg), and a tipping load of 3,600 lb (1,632.93 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,250lb
2,834.96kg
Engine power
61hp
45.49kW
Net Power
Rated operating capacity
1,750lb
793.79kg
Tipping load
3,600lb † — value reconstructed from related published figures
1,632.93kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the John Deere 250 Series II sits below the median for its class:

  • Operating weight 6,250 lb lighter than 62% (n=334)
  • Engine power 61 hp less powerful than 52% (n=335)
  • Rated operating capacity 1,750 lb lower-rated than 61% (n=288)

◇Scale drawingdrawn to scale · mm

1950C244D3196A2591B
Side elevation
1950C1775E
Front elevation

01 Engine Specification

Number Of Cylinders 3
Engine Make 2240
Engine Model 3029T
Gross Power 64.4hp 48.1kw
Net Power 61hp 45.5kw
Power Measured @ 2400rpm
Displacement 179cu in 3L

02 Operational Specification

Operational Weight 6250lb 2835kg
Fuel Capacity 15gal 57L
Max Speed 6.8mph 11km/h
Operating Speed 6.8mph 11km/h
Operating Voltage 12V

03 Loader Specification

Breakout Force 5500lb 2495kg
Operating Load Rating 1750lb 793.8kg

04 Hydraulic Specification

Pump Type Hydrostatic
Pump Flow Capacity 17.6gal/min 66.7L/min
Relief Valve Pressure 3100psi 21373.8kPa

05 Dimensions Dimensions

Length With Bucket 10.49ft in 3196mm
Width Over Tires 5.83ft in 1775mm
Ground Clearance 9.61in 244mm
Height To Top Of Cab 6.4ft in 1950mm
Wheelbase 3.53ft in 1075mm
Length W/O Bucket 8.51ft in 2591mm
Reach At Max Lift And Dump 28.15in 715mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.