Specification sheet Wheel Loader Ref john-deere-244j-wheel-loader

John Deere 244J

The John Deere 244J is a wheel loader with an operating weight of 11,552 lb (5,240 kg), a 59 hp engine, and a 1 yd³ (0.8 m³) bucket.

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
11,552lb
5,240kg
Engine power
59hp
44kW
Net Power
Bucket capacity
1yd³
0.8m³

Where it sits in its classpercentile · compact wheel loaders

Among 374 compact wheel loaders (≤22,000 lb), the John Deere 244J sits in the middle of its class:

  • Operating weight 11,550 lb lighter than 58% (n=374)
  • Engine power 59 hp less powerful than 68% (n=367)
  • Bucket capacity 1 yd³ smaller-bucket than 79% (n=309)

Scale drawingdrawn to scale · mm

2725B295C5280A
Side elevation
2725B2150D
Front elevation

01 Engine Specification

Engine Make 2240
Engine Model e 4024T
Net Power 59hp 44kw
Gross Power 64hp 48kw
Max Torque 163lb ft 221Nm
Displacement 149cu in 2.4L
Aspiration Turbocharged
Torque Rise 47.3%

02 Operational Specification

Operating Weight 11552lb 5240kg
Fuel Capacity 22gal 81L
Hydraulic System Fluid Capacity 16gal 60L
Engine Oil Fluid Capacity — value corrected — the source published it under the wrong unit 2.245gal 8.5L
Cooling System Fluid Capacity — value corrected — the source published it under the wrong unit 2.642gal 10L
Front Axle/Diff Fluid Capacity — value corrected — the source published it under the wrong unit 1.057gal 4L
Rear Axle/Diff Fluid Capacity — value corrected — the source published it under the wrong unit 1.083gal 4.1L
Static Tipping Weight 8457lb 3836kg
Turning Radius 11.5ft in 3505mm
Operating Voltage 12V
Alternator Supplied Amperage 65amps
Rear Axle Oscillation 20degrees
Tire Size 365/70R18

03 Transmission Specification

Transmission Type Hydrostatic
Number Of Forward Gears 2
Number Of Reverse Gears 2
Max Speed - Forward 18.6mph 30km/h
Max Speed - Reverse 18.6mph 30km/h

04 Hydraulic System Specification

Relief Valve Setting 3190psi 21980kPa
Pump Flow Capacity 17gal/min 64L/min
Raise Time 4.9sec
Dump Time 1.4sec
Lower Time 4sec
Pump Type Gear

05 Bucket Dimensions

Dump Clearance At Max Raise 8.33ft in 2550mm
Bucket Capacity - Heaped 1yd3 0.8m3
Bucket Capacity - Struck 0.86yd3 0.66m3
Bucket Width — value corrected — the source published it under the wrong unit 6.23ft in 1900mm
Breakout Force 10792lb 48kN

06 Dimensions Dimensions

Ground Clearance 1ft in 295mm
Length With Bucket On Ground 17.33ft in 5280mm
Width Over Tires 7ft in 2150mm
Height To Top Of Cab 8.92ft in 2725mm
Wheelbase 7ft in 2150mm
Hinge Pin - Max Height 10.5ft in 3210mm
Reach At Max Lift And Dump 2.68ft in 818mm

Data notes

Corrected value. The source published these figures under the wrong unit. The metric figure is authoritative and the imperial value shown here is derived from it.

  • Engine Oil Fluid Capacity: shown as 2.245 gal (source stated a value inconsistent with its own metric figure of 8.5 L)
  • Cooling System Fluid Capacity: shown as 2.642 gal (source stated a value inconsistent with its own metric figure of 10 L)
  • Front Axle/Diff Fluid Capacity: shown as 1.057 gal (source stated a value inconsistent with its own metric figure of 4 L)
  • Rear Axle/Diff Fluid Capacity: shown as 1.083 gal (source stated a value inconsistent with its own metric figure of 4.1 L)
  • Bucket Width: shown as 6.23 ft in (source stated a value inconsistent with its own metric figure of 1900 mm)

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.