Specification sheet Skid Steer Loader Ref john-deere-240-skid-steer-loader
John Deere 240
The John Deere 240 is a skid steer loader with an operating weight of 6,165 lb (2,796 kg), a 51 hp engine, and a rated operating capacity of 1,500 lb (681 kg).
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
6,165lb
2,796kg
Engine power
51hp
38kW
Net Power Rated operating capacity
1,500lb
681kg
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the John Deere 240 sits below the median for its class:
- Operating weight 6,170 lb lighter than 67% (n=334)
- Engine power 51 hp less powerful than 70% (n=335)
- Rated operating capacity 1,500 lb lower-rated than 77% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 3 | |
|---|---|---|
| Engine Make | 2240 | |
| Engine Model | 3029D | |
| Gross Power | 53hp | 39.5kw |
| Net Power | 51hp | 38kw |
| Power Measured @ | 2400rpm | |
| Displacement | 179cu in | 2.9L |
02 Operational Specification
| Operational Weight | 6165lb | 2796kg |
|---|---|---|
| Fuel Capacity | 15gal | 57L |
| Cooling System Fluid Capacity | 2.8gal | 10.6L |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 55amps |
03 Loader Specification
| Breakout Force | 5500lb | 2495kg |
|---|---|---|
| Operating Load Rating | 1500lb | 681kg |
04 Hydraulic Specification
| Pump Type | Hydrostatic | |
|---|---|---|
| Pump Flow Capacity | 14.6gal/min | 55.3L/min |
| Relief Valve Pressure | 3100psi | 21374kPa |
05 Dimensions Dimensions
| Length With Bucket | 10.49ft in | 3196mm |
|---|---|---|
| Width Over Tires | 5.31ft in | 1618mm |
| Ground Clearance | 8.23in | 209mm |
| Height To Top Of Cab | 6.29ft in | 1915mm |
| Wheelbase | 3.53ft in | 1075mm |
| Length W/O Bucket | 8.51ft in | 2591mm |
| Clearance At Max Lift And Dump | 7.4ft in | 2255mm |
| Reach At Max Lift And Dump | 29.1in | 738mm |
| Turning Radius From Center - Machine Rear | 61.4in | 1559mm |
| Turning Radius From Center - Inc Bucket | 78.91in | 2004mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.