Specification sheet Skid Steer Loader Ref john-deere-125-skid-steer-loader

John Deere 125

The John Deere 125 is a skid steer loader with an operating weight of 5,470 lb (2,481 kg), a 40 hp engine, a rated operating capacity of 1,410 lb (640 kg), and a tipping load of 2,820 lb (1,279.13 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,470lb
2,481kg
Engine power
40hp
29.83kW
Net Power
Rated operating capacity
1,410lb
640kg
Tipping load
2,820lb † — value reconstructed from related published figures
1,279.13kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the John Deere 125 sits below the median for its class:

  • Operating weight 5,470 lb lighter than 80% (n=334)
  • Engine power 40 hp less powerful than 89% (n=335)
  • Rated operating capacity 1,410 lb lower-rated than 79% (n=288)

◇Scale drawingdrawn to scale · mm

2102C178D3016A2292B
Side elevation
2102C1502E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2353
Engine Model C190
Net Power 40hp 29.9kw
Power Measured @ 2800rpm
Displacement 119cu in 2L

02 Operational Specification

Operational Weight 5470lb 2481kg
Fuel Capacity 15gal 56.8L
Cooling System Fluid Capacity 3.1gal 11.4L
Hydraulic System Fluid Capacity 18gal 68L
Max Speed 6.1mph 9.8km/h
Operating Speed 6.1mph 9.8km/h
Tire Size 10-16.5,6PR flotation
Operating Voltage 12V

03 Loader Specification

Operating Load Rating 1410lb 640kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Type Open-center
Pump Flow Capacity 15gal/min 56.8L/min

05 Dimensions Dimensions

Length With Bucket 9.9ft in 3016mm
Width Over Tires 4.93ft in 1502mm
Ground Clearance 7in 178mm
Height To Top Of Cab 6.9ft in 2102mm
Wheelbase 2.92ft in 889mm
Length W/O Bucket 7.52ft in 2292mm
Clearance At Max Lift And Dump 6.47ft in 1971mm
Reach At Max Lift And Dump 19.5in 495mm
Turning Radius From Center - Machine Rear 51.25in 1306mm
Turning Radius From Center - Inc Bucket 51.25in 1306mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.