Specification sheet Wheel Loader Ref jcb-426htm-wheel-loader
JCB 426HTM
The JCB 426HTM is a wheel loader with an operating weight of 31,327.69 lb (14,210 kg), a 150 hp engine, and a 2.36 yd³ (1.8 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
31,327.69lb
14,210kg
Engine power
150hp
111.9kW
Net Power Bucket capacity
2.36yd³
1.8m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the JCB 426HTM sits in the middle of its class:
- Operating weight 31,330 lb heavier than 53% (n=439)
- Engine power 150 hp less powerful than 64% (n=408)
- Bucket capacity 2.4 yd³ smaller-bucket than 88% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Model | BTAA5.9C | |
| Net Power | 150hp | 111.9kw |
| Gross Power | 152hp | 113.4kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 455.1lb ft | 617Nm |
| Displacement | 360.1cu in | 5.9L |
| Torque Measured @ | 1600rpm | |
| Aspiration | turbocharged |
02 Operational Specification
| Operating Weight | 31327.7lb | 14210kg |
|---|---|---|
| Fuel Capacity | 60.8gal | 230L |
| Hydraulic System Fluid Capacity | 55.5gal | 210L |
| Engine Oil Fluid Capacity | 3.7gal | 14L |
| Cooling System Fluid Capacity | 9.3gal | 35L |
| Transmission Fluid Capacity | 8gal | 30L |
| Front Axle/Diff Fluid Capacity | 10.4gal | 39L |
| Rear Axle/Diff Fluid Capacity | 9.8gal | 37L |
| Static Tipping Weight | 19158.2lb | 8690kg |
| Turning Radius | 19.3ft in | 5860mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 70amps | |
| Tire Size | 20.5r25 HXA (L3) |
03 Transmission Specification
| Transmission Type | smooth powershift | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 24mph | 38.5km/h |
| Max Speed - Reverse | 15.1mph | 24.3km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3625psi | 24993.5kPa |
|---|---|---|
| Pump Flow Capacity | 34.9gal/min | 132L/min |
| Raise Time | 4.4sec | |
| Dump Time | 1sec | |
| Lower Time | 2.7sec | |
| Pump Type | twin variable displacement piston pumps w/ load sensing system |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.29ft in | 2831mm |
|---|---|---|
| Breakout Force | 31023.64lb | 138kN |
| Bucket Capacity - Heaped | 2.36yd3 | 1.8m3 |
| Bucket Capacity - Struck | 2.04yd3 | 1.56m3 |
| Bucket Width | 8.37ft in | 2550mm |
06 Dimensions Dimensions
| Ground Clearance | 1.46ft in | 442mm |
|---|---|---|
| Length With Bucket On Ground | 22.15ft in | 6750mm |
| Height To Top Of Cab | 10.88ft in | 3315mm |
| Wheelbase | 9.85ft in | 3000mm |
| Hinge Pin - Max Height | 11.9ft in | 3627mm |
| Reach At Max Lift And Dump | 3.55ft in | 1081mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.