Specification sheet Wheel Loader Ref jcb-417-ht-shl-wheel-loader
JCB 417 HT SHL
The JCB 417 HT SHL is a wheel loader with an operating weight of 22,171.89 lb (10,057 kg), a 125 hp engine, and a 1.84 yd³ (1.4 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
22,171.89lb
10,057kg
Engine power
125hp
93.22kW
Gross Power Bucket capacity
1.84yd³
1.4m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the JCB 417 HT SHL sits at the compact end of its class:
- Operating weight 22,170 lb lighter than 99% (n=439)
- Engine power 125 hp less powerful than 88% (n=408)
- Bucket capacity 1.8 yd³ smaller-bucket than 99% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Model | JCB EcoMAX T4F | |
| Engine Type | 4 stroke direct injection | |
| Gross Power | 125hp | 93.3kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 550 Nm | |
| Displacement | 268.6cu in | 4.4L |
| Torque Measured @ | 1500rpm | |
| Aspiration | Turbo charged | |
| Bore | 4.1in | 103mm |
| Stroke | 5.2in | 132mm |
02 Operational Specification
| Def Tank Capacity | 5.3gal | 20L |
|---|---|---|
| Auxiliary Fuel Tank | 29.4gal | 111L |
| Operating Weight | 22171.9lb | 10057kg |
| Fuel Capacity | 30.7gal | 116L |
| Hydraulic System Fluid Capacity | 41gal | 155L |
| Turning Radius | 19.4ft in | 5913mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 100amps | |
| Rear Axle Oscillation | 11degrees | |
| Articulation Angle | 40degrees |
03 Transmission Specification
| Transmission Type | Smooth shift Powershift ZF 4WG115 | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 31.1mph | 50km/h |
| Max Speed - Reverse | 23.7mph | 38km/h |
04 Hydraulic System Specification
| Max Operating Pressure | 240 bar | |
|---|---|---|
| Relief Valve Setting | 3190psi | 21994.3kPa |
| Pump Flow Capacity | 41.3gal/min | 156L/min |
| Raise Time | 4.9sec | |
| Dump Time | 2.1sec | |
| Lower Time | 3.3sec | |
| Total Cycle | 10.3sec | |
| Pump Type | Variable placement piston pump |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 11.73ft in | 3575mm |
|---|---|---|
| Bucket Capacity - Heaped | 1.84yd3 | 1.4m3 |
| Bucket Capacity - Struck | 1.55yd3 | 1.18m3 |
| Bucket Width | 7.88ft in | 2400mm |
| Breakout Force | 15736.63lb | 70kN |
06 Dimensions Dimensions
| Ground Clearance | 1.22ft in | 371mm |
|---|---|---|
| Length With Bucket On Ground | 23.44ft in | 7143mm |
| Width Over Tires | 7.64ft in | 2328mm |
| Height To Top Of Cab | 10.12ft in | 3084mm |
| Wheelbase | 9.19ft in | 2800mm |
| Hinge Pin - Max Height | 14.48ft in | 4411mm |
| Reach At Max Lift And Dump | 3.53ft in | 1074mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.