Specification sheet Wheel Loader Ref jcb-416ht-super-high-lift-wheel-loader
JCB 416HT Super High Lift
The JCB 416HT Super High Lift is a wheel loader with an operating weight of 22,396.76 lb (10,159 kg), a 84.3 hp engine, and a 1.84 yd³ (1.4 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
22,396.76lb
10,159kg
Engine power
84.3hp
62.9kW
Net Power Bucket capacity
1.84yd³
1.4m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the JCB 416HT Super High Lift sits at the compact end of its class:
- Operating weight 22,400 lb lighter than 98% (n=439)
- Engine power 84 hp less powerful than 100% (n=408)
- Bucket capacity 1.8 yd³ smaller-bucket than 99% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2257 | |
| Net Power | 84.3hp | 62.9kw |
| Gross Power | 90.5hp | 67.5kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 320.2lb ft | 434Nm |
| Displacement | 268.6cu in | 4.4L |
| Torque Measured @ | 1400rpm | |
| Aspiration | turbocharged |
02 Operational Specification
| Operating Weight | 22396.8lb | 10159kg |
|---|---|---|
| Fuel Capacity | 37gal | 140L |
| Hydraulic System Fluid Capacity | 33.1gal | 125L |
| Engine Oil Fluid Capacity | 2.9gal | 10.7L |
| Cooling System Fluid Capacity | 6.1gal | 23L |
| Transmission Fluid Capacity | 6.9gal | 26L |
| Front Axle/Diff Fluid Capacity | 6.1gal | 23L |
| Rear Axle/Diff Fluid Capacity | 6.1gal | 23L |
| Static Tipping Weight | 13752.5lb | 6238kg |
| Turning Radius | 17.8ft in | 5410mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 55amps | |
| Rear Axle Oscillation | 25degrees | |
| Tire Size | Michelin 17.5R25 XHA (L3) |
03 Transmission Specification
| Transmission Type | smooth shift powershift | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 22.6mph | 36.3km/h |
| Max Speed - Reverse | 16.3mph | 26.2km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3190psi | 21994.3kPa |
|---|---|---|
| Pump Flow Capacity | 41.3gal/min | 156L/min |
| Raise Time | 4.6sec | |
| Dump Time | 1.4sec | |
| Lower Time | 3sec | |
| Pump Type | variable displacement piston pump |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 11.34ft in | 3454mm |
|---|---|---|
| Breakout Force | 22795.63lb | 101.4kN |
| Bucket Capacity - Heaped | 1.84yd3 | 1.4m3 |
| Bucket Capacity - Struck | 1.55yd3 | 1.18m3 |
| Bucket Width | 7.88ft in | 2400mm |
06 Dimensions Dimensions
| Ground Clearance | 1.47ft in | 448mm |
|---|---|---|
| Length With Bucket On Ground | 19.9ft in | 6064mm |
| Height To Top Of Cab | 10.35ft in | 3152mm |
| Wheelbase | 9.19ft in | 2800mm |
| Hinge Pin - Max Height | 13.97ft in | 4257mm |
| Reach At Max Lift And Dump | 3.93ft in | 1195mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.