Specification sheet Wheel Loader Ref jcb-413s-ht-wheel-loader
JCB 413S HT
The JCB 413S HT is a wheel loader with an operating weight of 19,958.45 lb (9,053 kg), a 145.2 hp engine, and a 1.57 yd³ (1.2 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
19,958.45lb
9,053kg
Engine power
145.2hp
108.28kW
Gross Power Bucket capacity
1.57yd³
1.2m³
◆Where it sits in its classpercentile · compact wheel loaders
Among 374 compact wheel loaders (≤22,000 lb), the JCB 413S HT sits at the heavy end of its class:
- Operating weight 19,960 lb heavier than 89% (n=374)
- Engine power 145 hp more powerful than 99% (n=367)
- Bucket capacity 1.6 yd³ larger-bucket than 59% (n=309)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Emission Tier Level | Tier 4 Final | |
|---|---|---|
| Number Of Cylinders | 4 | |
| No. Of Valves | 4 | |
| Engine Model | JCB EcoMAX T4F | |
| Air Cleaner | Cyclonic pre filter with engine fan scavenge system | |
| Gross Power | 145.2hp | 108.3kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 560 Nm | |
| Displacement | 293cu in | 4.8L |
| Torque Measured @ | 1500rpm | |
| Aspiration | Turbo charged |
02 Operational Specification
| Def Tank Capacity | 5.3gal | 20L |
|---|---|---|
| Auxiliary Fuel Tank | 29.4gal | 111L |
| Full Turn Tipping Load | 12381.2lb | 5616kg |
| Payload | 6190.6lb | 2808kg |
| Operating Weight | 19958.5lb | 9053kg |
| Fuel Capacity | 30.7gal | 116L |
| Hydraulic System Fluid Capacity | 41gal | 155L |
| Turning Radius | 17.9ft in | 5445mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 100amps | |
| Rear Axle Oscillation | 11degrees | |
| Articulation Angle | 40degrees |
03 Transmission Specification
| Transmission Type | 6 speed non-lock up converter ZF 6WG115 | |
|---|---|---|
| Number Of Forward Gears | 6 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 31.1mph | 50km/h |
| Max Speed - Reverse | 24.4mph | 39.2km/h |
04 Hydraulic System Specification
| Max Operating Pressure | 240 bar | |
|---|---|---|
| Relief Valve Setting | 3190psi | 21994.3kPa |
| Pump Flow Capacity | 41.3gal/min | 156L/min |
| Raise Time | 4.4sec | |
| Dump Time | 1.7sec | |
| Lower Time | 2.8sec | |
| Total Cycle | 8.9sec | |
| Pump Type | Variable placement piston pump |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.11ft in | 2775mm |
|---|---|---|
| Bucket Capacity - Heaped | 1.57yd3 | 1.2m3 |
| Bucket Capacity - Struck | 1.33yd3 | 1.01m3 |
| Bucket Width | 7.39ft in | 2250mm |
| Breakout Force | 16456.02lb | 73.2kN |
06 Dimensions Dimensions
| Ground Clearance | 1.16ft in | 351mm |
|---|---|---|
| Length With Bucket On Ground | 21.41ft in | 6524mm |
| Width Over Tires | 7.71ft in | 2347mm |
| Height To Top Of Cab | 10.06ft in | 3064mm |
| Wheelbase | 9.03ft in | 2750mm |
| Hinge Pin - Max Height | 11.75ft in | 3579mm |
| Reach At Max Lift And Dump | 3.08ft in | 937mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.