JCB 330
The JCB 330 is a skid steer loader with an operating weight of 9,735.62 lb (4,416 kg), a 92 hp engine, a rated operating capacity of 3,295 lb (1,494.59 kg), and a tipping load of 6,589.7 lb (2,989.04 kg).
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the JCB 330 sits at the heavy end of its class:
- Operating weight 9,740 lb heavier than 96% (n=334)
- Engine power 92 hp more powerful than 97% (n=335)
- Rated operating capacity 3,300 lb higher-rated than 95% (n=288)
◇Scale drawingdrawn to scale · mm
01 Tyres Specification
| Standard | 14 x 17.5 - 12 PR Xtra Wall Off Road |
|---|
02 Engine Specification
| Engine Oil Service Interval | 500 hours | |
|---|---|---|
| Engine Make | 2257 | |
| Engine Model | TC-68 | |
| Gross Power | 92hp | 68.7kw |
| Power Measured @ | 2400rpm | |
| Max Torque | 301lb ft | 408.2Nm |
| Torque Measured @ | 1800rpm | |
| Aspiration | Turbocharged | |
| Displacement | 268cu in | 4.4L |
03 Operational Specification
| Operational Weight | 9735.7lb | 4416kg |
|---|---|---|
| Fuel Capacity | 27.3gal | 103L |
| Cooling System Fluid Capacity | 4.1gal | 15.5L |
| Engine Oil Fluid Capacity | 4gal | 15L |
| Hydraulic System Fluid Capacity | 14.6gal | 55L |
| Max Speed | 13.5mph | 21.8km/h |
| Chain Box Fluid Capacity - Each Side | 6.1gal | 23L |
| Operating Speed | 7.3mph | 11.8km/h |
| Tire Size | 12 x 16.5 | |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 95amps |
04 Transmission Specification
| Model | Two Speed | |
|---|---|---|
| Travel Speed | 12.5mph | 20km/h |
05 Loader Specification
| Loader Lift Capacity With Bucket | 6056.1lb | 2747kg |
|---|---|---|
| Breakout Force | 6543.4lb | 2968kg |
| Operating Load Rating | 3295lb | 1494.6kg |
| Bucket Capacity | 0.6yd3 | 0.5m3 |
| Bucket Width | 74.9in | 1900mm |
06 Hydraulic Specification
| Pump Flow Capacity | 23.8gal/min | 90L/min |
|---|---|---|
| Relief Valve Pressure | 3335psi | 22994kPa |
07 Dimensions Dimensions
| Length With Bucket | 12.47ft in | 3800mm |
|---|---|---|
| Width Over Tires | 6.24ft in | 1900mm |
| Ground Clearance | 9.06in | 230mm |
| Height To Top Of Cab | 6.83ft in | 2080mm |
| Wheelbase | 6.93ft in | 2110mm |
| Clearance At Max Lift And Dump | 8.17ft in | 2490mm |
| Reach At Max Lift And Dump | 35.44in | 900mm |
| Rollback - Ground Level | 30degrees | |
| Turning Radius From Center - Inc Bucket | 86.62in | 2200mm |
| Turning Radius From Center - Machine Rear | 69.3in | 1760mm |
| Angle Of Departure | 29degrees | |
| Dump Angle | 42degrees |
Data notes
Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.