Specification sheet Skid Steer Loader Ref hyundai-hsl960t-skid-steer-loader

Hyundai HSL960T

The Hyundai HSL960T is a skid steer loader with an operating weight of 7,200.3 lb (3,266 kg), a 56 hp engine, a rated operating capacity of 2,101.01 lb (953 kg), and a tipping load of 4,250.6 lb (1,928.04 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,200.3lb
3,266kg
Engine power
56hp
41.76kW
Net Power
Rated operating capacity
2,101.01lb
953kg
Tipping load
4,250.6lb † — value reconstructed from related published figures
1,928.04kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Hyundai HSL960T sits above the median for its class:

  • Operating weight 7,200 lb heavier than 63% (n=334)
  • Engine power 56 hp less powerful than 66% (n=335)
  • Rated operating capacity 2,100 lb higher-rated than 63% (n=288)

◇Scale drawingdrawn to scale · mm

2121C222D3550A2838B
Side elevation
2121C1727E
Front elevation

01 Engine Specification

Engine Make 2334
Engine Model V2003MT
Gross Power 59.5hp 44.4kw
Net Power 56hp 41.8kw
Power Measured @ 2800rpm

02 Operational Specification

Operational Weight 7200.3lb 3266kg
Fuel Capacity 21.2gal 80L
Hydraulic System Fluid Capacity 17.5gal 66L
Operating Speed 7.8mph 12.4km/h
Tire Size 12x16.5

03 Loader Specification

Operating Load Rating 2101.1lb 953kg

04 Hydraulic Specification

Pump Flow Capacity 20gal/min 75.7L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Length With Bucket 11.65ft in 3550mm
Width Over Tires 5.67ft in 1727mm
Ground Clearance 8.75in 222mm
Height To Top Of Cab 6.96ft in 2121mm
Wheelbase 3.51ft in 1069mm
Length W/O Bucket 9.32ft in 2838mm
Clearance At Max Lift And Dump 7.92ft in 2413mm
Reach At Max Lift And Dump 30.99in 787mm
Turning Radius From Center - Machine Rear 67.52in 1715mm
Turning Radius From Center - Inc Bucket 83.59in 2123mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.