Specification sheet Skid Steer Loader Ref hyundai-hsl850-7-skid-steer-loader

Hyundai HSL850-7

The Hyundai HSL850-7 is a skid steer loader with an operating weight of 7,253.21 lb (3,290 kg), a 66 hp engine, a rated operating capacity of 1,852 lb (840.06 kg), and a tipping load of 3,715 lb (1,685.1 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,253.21lb
3,290kg
Engine power
66hp
49.22kW
Net Power
Rated operating capacity
1,852lb
840.06kg
Tipping load
3,715lb † — value reconstructed from related published figures
1,685.1kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Hyundai HSL850-7 sits above the median for its class:

  • Operating weight 7,250 lb heavier than 64% (n=334)
  • Engine power 66 hp more powerful than 53% (n=335)
  • Rated operating capacity 1,850 lb lower-rated than 52% (n=288)

◇Scale drawingdrawn to scale · mm

2000C205D3470A2840B
Side elevation
2000C1830E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V3300DI
Gross Power 68hp 50.8kw
Net Power 66hp 49.3kw
Power Measured @ 2400rpm

02 Operational Specification

Operational Weight 7253.3lb 3290kg
Fuel Capacity 22gal 83.3L
Hydraulic System Fluid Capacity 15gal 56.8L
Max Speed 7.2mph 11.6km/h
Tire Size 12-16.5 12PR

03 Loader Specification

Operating Load Rating 1852lb 840.1kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 17.7gal/min 67L/min
Relief Valve Pressure 2538psi 17498.9kPa

05 Dimensions Dimensions

Length With Bucket 11.39ft in 3470mm
Width Over Tires 6.01ft in 1830mm
Ground Clearance 8.08in 205mm
Height To Top Of Cab 6.57ft in 2000mm
Wheelbase 3.61ft in 1100mm
Length W/O Bucket 9.32ft in 2840mm
Clearance At Max Lift And Dump 7.91ft in 2410mm
Reach At Max Lift And Dump 20.08in 510mm
Turning Radius From Center - Machine Rear 65.36in 1660mm
Turning Radius From Center - Inc Bucket 81.89in 2080mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.