Specification sheet Skid Steer Loader Ref hyundai-hsl800t-skid-steer-loader

Hyundai HSL800T

The Hyundai HSL800T is a skid steer loader with an operating weight of 6,999.68 lb (3,175 kg), a 56 hp engine, a rated operating capacity of 1,750.48 lb (794 kg), and a tipping load of 3,496.6 lb (1,586.03 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,999.68lb
3,175kg
Engine power
56hp
41.76kW
Net Power
Rated operating capacity
1,750.48lb
794kg
Tipping load
3,496.6lb † — value reconstructed from related published figures
1,586.03kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Hyundai HSL800T sits in the middle of its class:

  • Operating weight 7,000 lb heavier than 57% (n=334)
  • Engine power 56 hp less powerful than 66% (n=335)
  • Rated operating capacity 1,750 lb lower-rated than 57% (n=288)

◇Scale drawingdrawn to scale · mm

2108C222D3538A2801B
Side elevation
2108C1727E
Front elevation

01 Engine Specification

Engine Make 2334
Engine Model V2003T
Gross Power 59.5hp 44.4kw
Net Power 56hp 41.8kw
Power Measured @ 2800rpm

02 Operational Specification

Operational Weight 6999.7lb 3175kg
Fuel Capacity 19.3gal 73L
Hydraulic System Fluid Capacity 14.8gal 56L
Max Speed 7.8mph 12.4km/h
Tire Size 12.00X16.5

03 Loader Specification

Operating Load Rating 1750.5lb 794kg

04 Hydraulic Specification

Pump Flow Capacity 16.6gal/min 62.8L/min
Relief Valve Pressure 2400psi 16547.5kPa

05 Dimensions Dimensions

Length With Bucket 11.61ft in 3538mm
Width Over Tires 5.67ft in 1727mm
Ground Clearance 8.75in 222mm
Height To Top Of Cab 6.92ft in 2108mm
Wheelbase 3.3ft in 1003mm
Length W/O Bucket 9.19ft in 2801mm
Clearance At Max Lift And Dump 9.24ft in 2814mm
Reach At Max Lift And Dump 29.49in 749mm
Turning Radius From Center - Machine Rear 65.52in 1664mm
Turning Radius From Center - Inc Bucket 82.52in 2096mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.