Specification sheet Skid Steer Loader Ref hyundai-hsl650-7-skid-steer-loader
Hyundai HSL650-7
The Hyundai HSL650-7 is a skid steer loader with an operating weight of 5,787 lb (2,624.94 kg), a 42.6 hp engine, a rated operating capacity of 1,433 lb (650 kg), and a 0.5 yd³ (0.4 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
5,787lb
2,624.94kg
Engine power
42.6hp
31.77kW
Net Power Rated operating capacity
1,433lb
650kg
Bucket capacity
0.5yd³
0.4m³
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Hyundai HSL650-7 sits below the median for its class:
- Operating weight 5,790 lb lighter than 73% (n=334)
- Engine power 43 hp less powerful than 87% (n=335)
- Rated operating capacity 1,430 lb lower-rated than 78% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2334 | |
| Engine Model | V2203M | |
| Gross Power | 44.2hp | 33kw |
| Net Power | 42.6hp | 31.8kw |
| Power Measured @ | 2500rpm | |
| Displacement | 134.3cu in | 2.2L |
02 Operational Specification
| Operational Weight | 5787lb | 2625kg |
|---|---|---|
| Fuel Capacity | 16gal | 60.6L |
| Max Speed | 7.3mph | 11.8km/h |
| Hydraulic System Fluid Capacity | 10gal | 37.9L |
| Tire Size | 10-16.5, 6PR |
03 Loader Specification
| Operating Load Rating | 1433lb | 650kg |
|---|---|---|
| Bucket Capacity | 0.5yd3 | 0.4m3 |
04 Hydraulic Specification
| Pump Flow Capacity | 18.4gal/min | 69.4L/min |
|---|---|---|
| Relief Valve Pressure | 2538psi | 17498.9kPa |
05 Dimensions Dimensions
| Length With Bucket | 10.73ft in | 3270mm |
|---|---|---|
| Width Over Tires | 4.98ft in | 1515mm |
| Ground Clearance | 7.21in | 183mm |
| Height To Top Of Cab | 6.45ft in | 1965mm |
| Wheelbase | 3.25ft in | 990mm |
| Length W/O Bucket | 8.62ft in | 2625mm |
| Clearance At Max Lift And Dump | 7.35ft in | 2240mm |
| Reach At Max Lift And Dump | 21.66in | 550mm |
| Turning Radius From Center - Machine Rear | 61.42in | 1560mm |
| Turning Radius From Center - Inc Bucket | 76.19in | 1935mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.