Specification sheet Skid Steer Loader Ref hyundai-hsl610-skid-steer-loader

Hyundai HSL610

The Hyundai HSL610 is a skid steer loader with an operating weight of 5,247.01 lb (2,380 kg), a 40.3 hp engine, a rated operating capacity of 1,344.82 lb (610 kg), and a tipping load of 2,700.7 lb (1,225.02 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,247.01lb
2,380kg
Engine power
40.3hp
30.06kW
Net Power
Rated operating capacity
1,344.82lb
610kg
Tipping load
2,700.7lb † — value reconstructed from related published figures
1,225.02kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Hyundai HSL610 sits below the median for its class:

  • Operating weight 5,250 lb lighter than 84% (n=334)
  • Engine power 40 hp less powerful than 89% (n=335)
  • Rated operating capacity 1,340 lb lower-rated than 85% (n=288)

◇Scale drawingdrawn to scale · mm

1955C183D3248A2600B
Side elevation
1955C1525E
Front elevation

01 Engine Specification

Engine Make 2348
Engine Model 4TNE88
Gross Power 41.4hp 30.9kw
Net Power 40.3hp 30.1kw
Power Measured @ 2500rpm

02 Operational Specification

Operational Weight 5247.1lb 2380kg
Fuel Capacity 15.5gal 58.6L
Hydraulic System Fluid Capacity 9.8gal 37L
Max Speed 6.6mph 10.5km/h
Tire Size 10-16.5

03 Loader Specification

Operating Load Rating 1344.9lb 610kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 16.2gal/min 61L/min
Relief Valve Pressure 2440psi 16823.2kPa

05 Dimensions Dimensions

Length With Bucket 10.66ft in 3248mm
Width Over Tires 5.01ft in 1525mm
Ground Clearance 7.21in 183mm
Height To Top Of Cab 6.42ft in 1955mm
Wheelbase 3.01ft in 915mm
Length W/O Bucket 8.54ft in 2600mm
Clearance At Max Lift And Dump 7.29ft in 2220mm
Reach At Max Lift And Dump 27.17in 690mm
Turning Radius From Center - Machine Rear 60.83in 1545mm
Turning Radius From Center - Inc Bucket 74.61in 1895mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.