Specification sheet Skid Steer Loader Ref hyundai-hsl600t-skid-steer-loader

Hyundai HSL600T

The Hyundai HSL600T is a skid steer loader with an operating weight of 5,350.62 lb (2,427 kg), a 39 hp engine, a rated operating capacity of 1,300 lb (589.68 kg), and a tipping load of 2,700.7 lb (1,225.02 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,350.62lb
2,427kg
Engine power
39hp
29.09kW
Net Power
Rated operating capacity
1,300lb
589.68kg
Tipping load
2,700.7lb † — value reconstructed from related published figures
1,225.02kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Hyundai HSL600T sits below the median for its class:

  • Operating weight 5,350 lb lighter than 83% (n=334)
  • Engine power 39 hp less powerful than 89% (n=335)
  • Rated operating capacity 1,300 lb lower-rated than 88% (n=288)

◇Scale drawingdrawn to scale · mm

1867C191D3246A2652B
Side elevation
1867C1461E
Front elevation

01 Engine Specification

Engine Make 2334
Engine Model V1903E
Gross Power 43hp 32.1kw
Net Power 39hp 29.1kw
Power Measured @ 2800rpm

02 Operational Specification

Operational Weight 5350.7lb 2427kg
Fuel Capacity 17gal 64L
Hydraulic System Fluid Capacity 8.1gal 30.3L
Max Speed 6.3mph 10km/h
Tire Size 10.00x16.5

03 Loader Specification

Operating Load Rating 1300lb 589.7kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 16.6gal/min 62.8L/min
Relief Valve Pressure 2400psi 16547.5kPa

05 Dimensions Dimensions

Length With Bucket 10.65ft in 3246mm
Width Over Tires 4.8ft in 1461mm
Ground Clearance 7.52in 191mm
Height To Top Of Cab 6.13ft in 1867mm
Wheelbase 2.92ft in 889mm
Length W/O Bucket 8.71ft in 2652mm
Clearance At Max Lift And Dump 7.49ft in 2281mm
Reach At Max Lift And Dump 28in 711mm
Turning Radius From Center - Machine Rear 61.89in 1572mm
Turning Radius From Center - Inc Bucket 72.6in 1844mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.