Specification sheet Skid Steer Loader Ref hyundai-hsl500t-skid-steer-loader

Hyundai HSL500T

The Hyundai HSL500T is a skid steer loader with an operating weight of 3,701.57 lb (1,679 kg), a 30.2 hp engine, a rated operating capacity of 1,000 lb (453.6 kg), and a tipping load of 1,999.6 lb (907 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
3,701.57lb
1,679kg
Engine power
30.2hp
22.53kW
Net Power
Rated operating capacity
1,000lb
453.6kg
Tipping load
1,999.6lb † — value reconstructed from related published figures
907kg
Bucket capacity
0.4yd³
0.3m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Hyundai HSL500T sits at the compact end of its class:

  • Operating weight 3,700 lb lighter than 93% (n=334)
  • Engine power 30 hp less powerful than 94% (n=335)
  • Rated operating capacity 1,000 lb lower-rated than 92% (n=288)

◇Scale drawingdrawn to scale · mm

1803C178D2921A2311B
Side elevation
1803C1289E
Front elevation

01 Engine Specification

Engine Make 2334
Engine Model V1305B
Gross Power 33hp 24.7kw
Net Power 30.2hp 22.6kw
Power Measured @ 3000rpm

02 Operational Specification

Operational Weight 3701.6lb 1679kg
Fuel Capacity 11.4gal 43L
Hydraulic System Fluid Capacity 9gal 34L
Max Speed 5.8mph 9.3km/h
Tire Size 10.5x15

03 Loader Specification

Operating Load Rating 1000lb 453.6kg
Bucket Capacity 0.4yd3 0.3m3

04 Hydraulic Specification

Pump Flow Capacity 8.8gal/min 33L/min
Relief Valve Pressure 2150psi 14823.8kPa

05 Dimensions Dimensions

Length With Bucket 9.59ft in 2921mm
Width Over Tires 4.23ft in 1289mm
Ground Clearance 7.01in 178mm
Height To Top Of Cab 5.92ft in 1803mm
Wheelbase 2.78ft in 846mm
Length W/O Bucket 7.59ft in 2311mm
Clearance At Max Lift And Dump 6.84ft in 2083mm
Reach At Max Lift And Dump 27.52in 699mm
Turning Radius From Center - Machine Rear 54.02in 1372mm
Turning Radius From Center - Inc Bucket 67.37in 1711mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.