Specification sheet Skid Steer Loader Ref hyundai-hsl400t-skid-steer-loader

Hyundai HSL400T

The Hyundai HSL400T is a skid steer loader with an operating weight of 3,000.5 lb (1,361 kg), a 15.8 hp engine, a rated operating capacity of 850 lb (385.56 kg), and a tipping load of 1,799 lb (816.01 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
3,000.5lb
1,361kg
Engine power
15.8hp
11.79kW
Net Power
Rated operating capacity
850lb
385.56kg
Tipping load
1,799lb † — value reconstructed from related published figures
816.01kg
Bucket capacity
0.3yd³
0.2m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Hyundai HSL400T sits at the compact end of its class:

  • Operating weight 3,000 lb lighter than 95% (n=334)
  • Engine power 16 hp less powerful than 100% (n=335)
  • Rated operating capacity 850 lb lower-rated than 95% (n=288)

◇Scale drawingdrawn to scale · mm

1814C171D2673A2121B
Side elevation
1814C908E
Front elevation

01 Engine Specification

Engine Make 2334
Engine Model D722B
Gross Power 19.8hp 14.8kw
Net Power 15.8hp 11.8kw
Power Measured @ 3100rpm

02 Operational Specification

Operational Weight 3000.5lb 1361kg
Fuel Capacity 14.6gal 55L
Hydraulic System Fluid Capacity 11.4gal 42.8L
Max Speed 5.1mph 8.1km/h
Tire Size 5.90x15

03 Loader Specification

Operating Load Rating 850lb 385.6kg
Bucket Capacity 0.3yd3 0.2m3

04 Hydraulic Specification

Pump Flow Capacity 8.1gal/min 30.3L/min
Relief Valve Pressure 2100psi 14479kPa

05 Dimensions Dimensions

Length With Bucket 8.77ft in 2673mm
Width Over Tires 2.98ft in 908mm
Ground Clearance 6.74in 171mm
Height To Top Of Cab 5.96ft in 1814mm
Wheelbase 2.76ft in 840mm
Length W/O Bucket 6.96ft in 2121mm
Clearance At Max Lift And Dump 5.76ft in 1753mm
Reach At Max Lift And Dump 14.49in 368mm
Turning Radius From Center - Machine Rear 48in 1219mm
Turning Radius From Center - Inc Bucket 60.2in 1529mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.