Specification sheet Skid Steer Loader Ref hyundai-hsl1200t-skid-steer-loader

Hyundai HSL1200T

The Hyundai HSL1200T is a skid steer loader with an operating weight of 8,000.58 lb (3,629 kg), a 83 hp engine, a rated operating capacity of 2,500.05 lb (1,134 kg), and a tipping load of 5,000.1 lb (2,268.01 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
8,000.58lb
3,629kg
Engine power
83hp
61.9kW
Net Power
Rated operating capacity
2,500.05lb
1,134kg
Tipping load
5,000.1lb † — value reconstructed from related published figures
2,268.01kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Hyundai HSL1200T sits above the median for its class:

  • Operating weight 8,000 lb heavier than 80% (n=334)
  • Engine power 83 hp more powerful than 85% (n=335)
  • Rated operating capacity 2,500 lb higher-rated than 81% (n=288)

◇Scale drawingdrawn to scale · mm

2134C229D3708A2985B
Side elevation
2134C1798E
Front elevation

01 Engine Specification

Engine Make 2334
Engine Model V3300T
Gross Power 87.4hp 65.2kw
Net Power 83hp 61.9kw
Power Measured @ 2700rpm

02 Operational Specification

Operational Weight 8000.6lb 3629kg
Fuel Capacity 28.8gal 109L
Hydraulic System Fluid Capacity 35.1gal 132.5L
Operating Speed 6.8mph 10.9km/h
Tire Size 12x16.5

03 Loader Specification

Operating Load Rating 2500.1lb 1134kg

04 Hydraulic Specification

Pump Flow Capacity 21.1gal/min 79.5L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Length With Bucket 12.17ft in 3708mm
Width Over Tires 5.9ft in 1798mm
Ground Clearance 9.02in 229mm
Height To Top Of Cab 7.01ft in 2134mm
Wheelbase 4.07ft in 1238mm
Length W/O Bucket 9.8ft in 2985mm
Clearance At Max Lift And Dump 8.07ft in 2459mm
Reach At Max Lift And Dump 25.32in 643mm
Turning Radius From Center - Machine Rear 69.81in 1773mm
Turning Radius From Center - Inc Bucket 84.02in 2134mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.