Specification sheet Wheel Loader Ref hyundai-hl740tm-7-wheel-loader
Hyundai HL740TM-7
The Hyundai HL740TM-7 is a wheel loader with an operating weight of 26,565.71 lb (12,050 kg), a 140 hp engine, and a 2.62 yd³ (2 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
26,565.71lb
12,050kg
Engine power
140hp
104.4kW
Net Power Bucket capacity
2.62yd³
2m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Hyundai HL740TM-7 sits below the median for its class:
- Operating weight 26,570 lb lighter than 76% (n=439)
- Engine power 140 hp less powerful than 74% (n=408)
- Bucket capacity 2.6 yd³ smaller-bucket than 76% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Make | 2347 | |
|---|---|---|
| Engine Model | QSB5.9-C | |
| Net Power | 140hp | 104.4kw |
| Gross Power | 133hp | 99.2kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 434lb ft | 588.5Nm |
| Displacement | 360.1cu in | 5.9L |
| Torque Measured @ | 1500rpm | |
| Aspiration | turbocharged |
02 Operational Specification
| Operating Weight | 26565.8lb | 12050kg |
|---|---|---|
| Fuel Capacity | 60.3gal | 228L |
| Hydraulic System Fluid Capacity | 43.6gal | 165L |
| Engine Oil Fluid Capacity | 4.3gal | 16L |
| Cooling System Fluid Capacity | 9.3gal | 35L |
| Transmission Fluid Capacity | 6.4gal | 24L |
| Front Axle/Diff Fluid Capacity | 5.7gal | 21.2L |
| Rear Axle/Diff Fluid Capacity | 5.7gal | 21.2L |
| Static Tipping Weight | 17530lb | 7951.5kg |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 70amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 20.5-25 16 PR, L3 |
03 Transmission Specification
| Transmission Type | 3-elements, single-stage single phase | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 23.8mph | 38.2km/h |
| Max Speed - Reverse | 15.8mph | 25.3km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3130psi | 21580.6kPa |
|---|---|---|
| Pump Flow Capacity | 46.8gal/min | 177L/min |
| Raise Time | 5.5sec | |
| Dump Time | 1.4sec | |
| Lower Time | 2.8sec | |
| Pump Type | open-centered, tandem circuit system |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.57ft in | 2915mm |
|---|---|---|
| Bucket Capacity - Heaped | 2.62yd3 | 2m3 |
| Bucket Capacity - Struck | 2.23yd3 | 1.7m3 |
| Bucket Width | 8.37ft in | 2550mm |
| Breakout Force | 23480lb | 104.45kN |
06 Dimensions Dimensions
| Ground Clearance | 1.37ft in | 417mm |
|---|---|---|
| Length With Bucket On Ground | 24.78ft in | 7550mm |
| Width Over Tires | 8.37ft in | 2550mm |
| Height To Top Of Cab | 10.7ft in | 3260mm |
| Wheelbase | 9.52ft in | 2900mm |
| Hinge Pin - Max Height | 13.1ft in | 3990mm |
| Reach At Max Lift And Dump | 4.19ft in | 1275mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.