Specification sheet Wheel Loader Ref hyundai-hl730tm-7-wheel-loader
Hyundai HL730TM-7
The Hyundai HL730TM-7 is a wheel loader with an operating weight of 22,046.23 lb (10,000 kg), a 119 hp engine, and a 2.1 yd³ (1.6 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
22,046.23lb
10,000kg
Engine power
119hp
88.8kW
Net Power Bucket capacity
2.1yd³
1.6m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Hyundai HL730TM-7 sits at the compact end of its class:
- Operating weight 22,050 lb lighter than 100% (n=439)
- Engine power 119 hp less powerful than 92% (n=408)
- Bucket capacity 2.1 yd³ smaller-bucket than 95% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2347 | |
| Engine Model | B3.9-C | |
| Net Power | 119hp | 88.8kw |
| Gross Power | 125hp | 93.3kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 373lb ft | 505.8Nm |
| Displacement | 238cu in | 3.9L |
| Torque Measured @ | 1300rpm | |
| Aspiration | turbocharged |
02 Operational Specification
| Operating Weight | 22046.3lb | 10000kg |
|---|---|---|
| Fuel Capacity | 53.4gal | 202L |
| Hydraulic System Fluid Capacity | 42.3gal | 160L |
| Engine Oil Fluid Capacity | 3gal | 11L |
| Cooling System Fluid Capacity | 8gal | 30L |
| Transmission Fluid Capacity | 5.3gal | 20L |
| Front Axle/Diff Fluid Capacity | 4.9gal | 18.4L |
| Rear Axle/Diff Fluid Capacity | 4.9gal | 18.4L |
| Static Tipping Weight | 14640lb | 6640.6kg |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 70amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 17.5-25, 12PR, L3 |
03 Transmission Specification
| Transmission Type | full automatic power shift countershaft type | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 23mph | 37km/h |
| Max Speed - Reverse | 14.5mph | 23.3km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 2990psi | 20615.4kPa |
|---|---|---|
| Pump Flow Capacity | 37gal/min | 140L/min |
| Raise Time | 5.4sec | |
| Dump Time | 1.4sec | |
| Lower Time | 2.4sec | |
| Pump Type | helical gear type |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.14ft in | 2785mm |
|---|---|---|
| Bucket Capacity - Heaped | 2.1yd3 | 1.6m3 |
| Bucket Capacity - Struck | 1.84yd3 | 1.4m3 |
| Breakout Force | 22240lb | 98.93kN |
06 Dimensions Dimensions
| Ground Clearance | 1.22ft in | 370mm |
|---|---|---|
| Length With Bucket On Ground | 22.97ft in | 7000mm |
| Width Over Tires | 7.88ft in | 2400mm |
| Height To Top Of Cab | 10.41ft in | 3170mm |
| Wheelbase | 9.03ft in | 2750mm |
| Hinge Pin - Max Height | 12.41ft in | 3780mm |
| Reach At Max Lift And Dump | 3.75ft in | 1140mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.