Specification sheet Skid Steer Loader Ref gehl-7810-skid-steer-loader
Gehl 7810
The Gehl 7810 is a skid steer loader with an operating weight of 10,260 lb (4,653.86 kg), a 115 hp engine, and a rated operating capacity of 3,675 lb (1,666.96 kg).
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
10,260lb
4,653.86kg
Engine power
115hp
85.76kW
Net Power Rated operating capacity
3,675lb
1,666.96kg
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Gehl 7810 sits at the heavy end of its class:
- Operating weight 10,260 lb heavier than 99% (n=334)
- Engine power 115 hp more powerful than 100% (n=335)
- Rated operating capacity 3,680 lb higher-rated than 98% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Make | 2351 | |
|---|---|---|
| Engine Model | 1104C-E44T turbo | |
| Net Power | 115hp | 85.8kw |
| Power Measured @ | 2400rpm | |
| Aspiration | turbocharged | |
| Displacement | 269cu in | 4.5L |
02 Operational Specification
| Operational Weight | 10260lb | 4653.9kg |
|---|---|---|
| Fuel Capacity | 28.8gal | 109L |
| Hydraulic System Fluid Capacity | 15.1gal | 57L |
| Max Speed | 7.5mph | 12km/h |
| Tire Size | 14.00x17.5 HD |
03 Loader Specification
| Operating Load Rating | 3675lb | 1667kg |
|---|
04 Hydraulic Specification
| Pump Flow Capacity | 29gal/min | 109.8L/min |
|---|---|---|
| Relief Valve Pressure | 3300psi | 22752.7kPa |
05 Dimensions Dimensions
| Length With Bucket | 13.42ft in | 4089mm |
|---|---|---|
| Width Over Tires | 6.75ft in | 2057mm |
| Ground Clearance | 9.1in | 231mm |
| Height To Top Of Cab | 6.75ft in | 2057mm |
| Wheelbase | 4.59ft in | 1397mm |
| Length W/O Bucket | 10.17ft in | 3099mm |
| Clearance At Max Lift And Dump | 8.92ft in | 2718mm |
| Reach At Max Lift And Dump | 38.19in | 970mm |
| Turning Radius From Center - Machine Rear | 40.26in | 1022.5mm |
| Turning Radius From Center - Inc Bucket | 50.85in | 1291.5mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.