Specification sheet Skid Steer Loader Ref gehl-6640-skid-steer-loader

Gehl 6640

The Gehl 6640 is a skid steer loader with an operating weight of 7,800 lb (3,538.03 kg), a 82 hp engine, a rated operating capacity of 2,400 lb (1,088.63 kg), and a tipping load of 4,800 lb (2,177.25 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,800lb
3,538.03kg
Engine power
82hp
61.15kW
Net Power
Rated operating capacity
2,400lb
1,088.63kg
Tipping load
4,800lb † — value reconstructed from related published figures
2,177.25kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Gehl 6640 sits above the median for its class:

  • Operating weight 7,800 lb heavier than 75% (n=334)
  • Engine power 82 hp more powerful than 82% (n=335)
  • Rated operating capacity 2,400 lb higher-rated than 73% (n=288)

◇Scale drawingdrawn to scale · mm

2082C231D3594A2565B
Side elevation
2082C1841E
Front elevation

01 Engine Specification

Engine Make 2349
Engine Model BF4M2011
Net Power 82hp 61.2kw
Power Measured @ 2500rpm
Displacement 190cu in 3.2L

02 Operational Specification

Operational Weight 7800lb 3538.1kg
Fuel Capacity 24.1gal 91L
Max Speed 8.4mph 13.5km/h
Hydraulic System Fluid Capacity 15.9gal 60L
Tire Size 14.00x17.5 HD
Operating Voltage 12V
Alternator Supplied Amperage 95amps

03 Loader Specification

Operating Load Rating 2400lb 1088.7kg

04 Hydraulic Specification

Pump Flow Capacity 23gal/min 87.1L/min

05 Dimensions Dimensions

Length With Bucket 11.8ft in 3594mm
Width Over Tires 6.04ft in 1841mm
Ground Clearance 9.1in 231mm
Height To Top Of Cab 6.84ft in 2082mm
Wheelbase 4ft in 1219mm
Length W/O Bucket 8.42ft in 2565mm
Clearance At Max Lift And Dump 7.91ft in 2408mm
Reach At Max Lift And Dump 33.98in 863mm
Turning Radius From Center - Machine Rear 34.51in 876.5mm
Turning Radius From Center - Inc Bucket 45.26in 1149.5mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.