Specification sheet Skid Steer Loader Ref gehl-5640-skid-steer-loader

Gehl 5640

The Gehl 5640 is a skid steer loader with an operating weight of 7,380 lb (3,347.52 kg), a 60 hp engine, a rated operating capacity of 2,000 lb (907.19 kg), and a tipping load of 4,000 lb (1,814.37 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,380lb
3,347.52kg
Engine power
60hp
44.75kW
Net Power
Rated operating capacity
2,000lb
907.19kg
Tipping load
4,000lb † — value reconstructed from related published figures
1,814.37kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Gehl 5640 sits above the median for its class:

  • Operating weight 7,380 lb heavier than 65% (n=334)
  • Engine power 60 hp less powerful than 56% (n=335)
  • Rated operating capacity 2,000 lb higher-rated than 56% (n=288)

◇Scale drawingdrawn to scale · mm

2057C203D3327A2426B
Side elevation
2057C1702E
Front elevation

01 Engine Specification

Engine Make 2349
Engine Model F4M2011
Net Power 60hp 44.8kw
Power Measured @ 2500rpm
Displacement 190cu in 3.2L

02 Operational Specification

Operational Weight 7380lb 3347.6kg
Fuel Capacity 19.1gal 72L
Max Speed 8.4mph 13.5km/h
Hydraulic System Fluid Capacity 15.9gal 60L
Tire Size 12.00x16.5 HD
Operating Voltage 12V
Alternator Supplied Amperage 95amps

03 Loader Specification

Operating Load Rating 2000lb 907.2kg

04 Hydraulic Specification

Pump Flow Capacity 23gal/min 87.1L/min

05 Dimensions Dimensions

Length With Bucket 10.92ft in 3327mm
Width Over Tires 5.59ft in 1702mm
Ground Clearance 8in 203mm
Height To Top Of Cab 6.75ft in 2057mm
Wheelbase 3.55ft in 1080mm
Length W/O Bucket 7.96ft in 2426mm
Clearance At Max Lift And Dump 7.8ft in 2375mm
Reach At Max Lift And Dump 32.8in 833mm
Turning Radius From Center - Machine Rear 33.06in 839.5mm
Turning Radius From Center - Inc Bucket 41.01in 1041.5mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.