Specification sheet Skid Steer Loader Ref gehl-5240e-skid-steer-loader

Gehl 5240E

The Gehl 5240E is a skid steer loader with an operating weight of 6,860.79 lb (3,112 kg), a 62 hp engine, a rated operating capacity of 1,900.39 lb (862 kg), and a tipping load of 3,800.8 lb (1,724.02 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,860.79lb
3,112kg
Engine power
62hp
46.24kW
Net Power
Rated operating capacity
1,900.39lb
862kg
Tipping load
3,800.8lb † — value reconstructed from related published figures
1,724.02kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Gehl 5240E sits in the middle of its class:

  • Operating weight 6,860 lb heavier than 51% (n=334)
  • Engine power 62 hp more powerful than 50% (n=335)
  • Rated operating capacity 1,900 lb lower-rated than 51% (n=288)

◇Scale drawingdrawn to scale · mm

1981C158D3208A2370B
Side elevation
1981C1575E
Front elevation

01 Engine Specification

Engine Make 2349
Engine Model TD2009
Net Power 62hp 46.3kw
Power Measured @ 2500rpm
Aspiration Turbocharged

02 Operational Specification

Operational Weight 6860.8lb 3112kg
Hydraulic System Fluid Capacity 11.9gal 45L
Tire Size 10.00x16.5 HD

03 Loader Specification

Operating Load Rating 1900.4lb 862kg

04 Hydraulic Specification

Pump Flow Capacity 19.1gal/min 72L/min

05 Dimensions Dimensions

Length With Bucket 10.53ft in 3208mm
Width Over Tires 5.17ft in 1575mm
Ground Clearance 6.23in 158mm
Height To Top Of Cab 6.5ft in 1981mm
Wheelbase 3.46ft in 1054mm
Length W/O Bucket 7.78ft in 2370mm
Clearance At Max Lift And Dump 7.46ft in 2273mm
Reach At Max Lift And Dump 25in 635mm
Turning Radius From Center - Machine Rear 61.5in 1562mm
Turning Radius From Center - Inc Bucket 75.99in 1930mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.