Specification sheet Skid Steer Loader Ref gehl-4840e-skid-steer-loader

Gehl 4840E

The Gehl 4840E is a skid steer loader with an operating weight of 6,200 lb (2,812.28 kg), a 60 hp engine, a rated operating capacity of 1,900 lb (861.83 kg), and a tipping load of 3,800 lb (1,723.65 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,200lb
2,812.28kg
Engine power
60hp
44.75kW
Net Power
Rated operating capacity
1,900lb
861.83kg
Tipping load
3,800lb † — value reconstructed from related published figures
1,723.65kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Gehl 4840E sits below the median for its class:

  • Operating weight 6,200 lb lighter than 66% (n=334)
  • Engine power 60 hp less powerful than 56% (n=335)
  • Rated operating capacity 1,900 lb lower-rated than 52% (n=288)

◇Scale drawingdrawn to scale · mm

1981B191C3208A
Side elevation
1981B1613D
Front elevation

01 Engine Specification

Engine Make 2349
Engine Model F4M2011
Net Power 60hp 44.8kw
Power Measured @ 2500rpm
Displacement 190cu in 3.2L

02 Operational Specification

Operational Weight 6200lb 2812.3kg
Fuel Capacity 15gal 56.8L
Max Speed 8.9mph 14.2km/h
Hydraulic System Fluid Capacity 11.9gal 45L
Tire Size 10.00x16.5 HD
Operating Voltage 12V
Alternator Supplied Amperage 95amps

03 Loader Specification

Operating Load Rating 1900lb 861.9kg

04 Hydraulic Specification

Pump Flow Capacity 19gal/min 72L/min

05 Dimensions Dimensions

Length With Bucket 10.53ft in 3208mm
Width Over Tires 5.3ft in 1613mm
Ground Clearance 7.52in 191mm
Height To Top Of Cab 6.5ft in 1981mm
Wheelbase 3.46ft in 1054mm
Clearance At Max Lift And Dump 7.46ft in 2273mm
Reach At Max Lift And Dump 27.6in 701mm
Turning Radius From Center - Machine Rear 30.75in 781mm
Turning Radius From Center - Inc Bucket 38in 965mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.