Specification sheet Skid Steer Loader Ref gehl-4240e-skid-steer-loader

Gehl 4240E

The Gehl 4240E is a skid steer loader with an operating weight of 4,600 lb (2,086.53 kg), a 46 hp engine, a rated operating capacity of 1,350 lb (612.35 kg), and a tipping load of 2,700 lb (1,224.7 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
4,600lb
2,086.53kg
Engine power
46hp
34.31kW
Net Power
Rated operating capacity
1,350lb
612.35kg
Tipping load
2,700lb † — value reconstructed from related published figures
1,224.7kg
Bucket capacity
0.6yd³
0.5m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Gehl 4240E sits at the compact end of its class:

  • Operating weight 4,600 lb lighter than 89% (n=334)
  • Engine power 46 hp less powerful than 82% (n=335)
  • Rated operating capacity 1,350 lb lower-rated than 83% (n=288)

◇Scale drawingdrawn to scale · mm

1826C211D2952A2314B
Side elevation
1826C1334E
Front elevation

01 Engine Specification

Engine Make 2348
Engine Model 4TNV88
Net Power 46hp 34.4kw
Power Measured @ 2600rpm
Displacement 133.7cu in 2.2L

02 Operational Specification

Operational Weight 4600lb 2086.6kg
Fuel Capacity 12.5gal 47L
Hydraulic System Fluid Capacity 8.1gal 30.3L
Max Speed 6.5mph 10.3km/h
Tire Size 10.00x16.5 HD
Operating Voltage 12V
Alternator Supplied Amperage 40amps

03 Loader Specification

Operating Load Rating 1350lb 612.4kg
Bucket Capacity 0.6yd3 0.5m3

04 Hydraulic Specification

Pump Flow Capacity 16.5gal/min 62.5L/min

05 Dimensions Dimensions

Length With Bucket 9.69ft in 2952mm
Width Over Tires 4.38ft in 1334mm
Ground Clearance 8.31in 211mm
Height To Top Of Cab 6ft in 1826mm
Wheelbase 3.06ft in 932mm
Length W/O Bucket 7.6ft in 2314mm
Clearance At Max Lift And Dump 7.05ft in 2146mm
Reach At Max Lift And Dump 22.6in 574mm
Turning Radius From Center - Machine Rear 29.22in 742mm
Turning Radius From Center - Inc Bucket 34.61in 879mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.