Specification sheet Skid Steer Loader Ref gehl-3640e-skid-steer-loader

Gehl 3640E

The Gehl 3640E is a skid steer loader with an operating weight of 4,000 lb (1,814.37 kg), a 35 hp engine, a rated operating capacity of 1,050 lb (476.28 kg), and a tipping load of 2,100 lb (952.55 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
4,000lb
1,814.37kg
Engine power
35hp
26.1kW
Net Power
Rated operating capacity
1,050lb
476.28kg
Tipping load
2,100lb † — value reconstructed from related published figures
952.55kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Gehl 3640E sits at the compact end of its class:

  • Operating weight 4,000 lb lighter than 92% (n=334)
  • Engine power 35 hp less powerful than 92% (n=335)
  • Rated operating capacity 1,050 lb lower-rated than 91% (n=288)

◇Scale drawingdrawn to scale · mm

1786C152D2896A2258B
Side elevation
1786C1229E
Front elevation

01 Engine Specification

Engine Make 2348
Engine Model 3TNV88
Net Power 35hp 26.1kw
Power Measured @ 2600rpm
Displacement 100.1cu in 1.7L

02 Operational Specification

Operational Weight 4000lb 1814.4kg
Fuel Capacity 10.3gal 38.9L
Hydraulic System Fluid Capacity 8.1gal 30.3L
Max Speed 6.8mph 10.9km/h
Tire Size 27x8.5x15 HD
Operating Voltage 12V
Alternator Supplied Amperage 40amps

03 Loader Specification

Operating Load Rating 1050lb 476.3kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 14.5gal/min 54.9L/min

05 Dimensions Dimensions

Length With Bucket 9.51ft in 2896mm
Width Over Tires 4.04ft in 1229mm
Ground Clearance 5.99in 152mm
Height To Top Of Cab 5.86ft in 1786mm
Wheelbase 2.88ft in 876mm
Length W/O Bucket 7.41ft in 2258mm
Clearance At Max Lift And Dump 7.05ft in 2146mm
Reach At Max Lift And Dump 22.8in 579mm
Turning Radius From Center - Machine Rear 27.05in 687mm
Turning Radius From Center - Inc Bucket 34.71in 881.5mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.