Specification sheet Skid Steer Loader Ref gehl-1640e-skid-steer-loader
Gehl 1640E
The Gehl 1640E is a skid steer loader with an operating weight of 2,980.65 lb (1,352 kg), a 24 hp engine, and a rated operating capacity of 850.99 lb (386 kg).
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
2,980.65lb
1,352kg
Engine power
24hp
17.9kW
Net Power Rated operating capacity
850.99lb
386kg
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Gehl 1640E sits at the compact end of its class:
- Operating weight 2,980 lb lighter than 95% (n=334)
- Engine power 24 hp less powerful than 96% (n=335)
- Rated operating capacity 850 lb lower-rated than 94% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Make | 2348 | |
|---|---|---|
| Engine Model | 3TNV82BPMS | |
| Net Power | 24hp | 17.9kw |
| Power Measured @ | 2400rpm | |
| Max Torque | 68lb ft | 92.2Nm |
| Torque Measured @ | 1200rpm | |
| Displacement | 81cu in | 1.4L |
02 Operational Specification
| Operational Weight | 2980.7lb | 1352kg |
|---|---|---|
| Fuel Capacity | 7.7gal | 29L |
| Hydraulic System Fluid Capacity | 7.2gal | 27L |
| Operating Speed | 5.5mph | 8.9km/h |
03 Loader Specification
| Operating Load Rating | 851lb | 386kg |
|---|
04 Hydraulic Specification
| Pump Flow Capacity | 10.1gal/min | 38.2L/min |
|---|---|---|
| Relief Valve Pressure | 2255psi | 15547.7kPa |
05 Dimensions Dimensions
| Length With Bucket | 8.46ft in | 2576mm |
|---|---|---|
| Width Over Tires | 2.99ft in | 909mm |
| Ground Clearance | 5.91in | 150mm |
| Height To Top Of Cab | 6.23ft in | 1897mm |
| Wheelbase | 2.55ft in | 775mm |
| Length W/O Bucket | 6.25ft in | 1905mm |
| Clearance At Max Lift And Dump | 6.03ft in | 1836mm |
| Reach At Max Lift And Dump | 14.81in | 376mm |
| Turning Radius From Center - Machine Rear | 43.19in | 1097mm |
| Turning Radius From Center - Inc Bucket | 58in | 1473mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.