Specification sheet Wheel Loader Ref doosan-mega200-v-wheel-loader
Doosan MEGA200-V
The Doosan MEGA200-V is a wheel loader with an operating weight of 24,691.78 lb (11,200 kg), a 138 hp engine, and a 2.49 yd³ (1.9 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
24,691.78lb
11,200kg
Engine power
138hp
103kW
Net Power Bucket capacity
2.49yd³
1.9m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Doosan MEGA200-V sits below the median for its class:
- Operating weight 24,690 lb lighter than 85% (n=439)
- Engine power 138 hp less powerful than 76% (n=408)
- Bucket capacity 2.5 yd³ smaller-bucket than 85% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2252 | |
| Engine Model | DB58Ti | |
| Net Power | 138hp | 103kw |
| Gross Power | 143hp | 106.7kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 412lb ft | 558.6Nm |
| Displacement | 354cu in | 5.8L |
| Torque Measured @ | 1600rpm | |
| Aspiration | turbocharged after cooled |
02 Operational Specification
| Operating Weight | 24691.8lb | 11200kg |
|---|---|---|
| Fuel Capacity | 68.7gal | 260L |
| Hydraulic System Fluid Capacity | 39.7gal | 150L |
| Engine Oil Fluid Capacity | 5.6gal | 21L |
| Cooling System Fluid Capacity | 8.2gal | 31L |
| Transmission Fluid Capacity | 8gal | 30L |
| Front Axle/Diff Fluid Capacity | 5.3gal | 20L |
| Rear Axle/Diff Fluid Capacity | 5.3gal | 20L |
| Static Tipping Weight | 18740lb | 8500.4kg |
| Turning Radius | 18.6ft in | 5659mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 50amps | |
| Rear Axle Oscillation | 22degrees | |
| Tire Size | 17.5-25 |
03 Transmission Specification
| Transmission Type | auto powershift countershaft | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 22.4mph | 36km/h |
| Max Speed - Reverse | 14.6mph | 23.4km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 2845psi | 19615.6kPa |
|---|---|---|
| Pump Flow Capacity | 46.3gal/min | 175L/min |
| Raise Time | 5sec | |
| Dump Time | 1.2sec | |
| Lower Time | 3.3sec | |
| Pump Type | gear type |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 8.96ft in | 2730mm |
|---|---|---|
| Bucket Capacity - Heaped | 2.49yd3 | 1.9m3 |
| Bucket Width | 8.37ft in | 2550mm |
| Breakout Force | 23800lb | 105.87kN |
06 Dimensions Dimensions
| Ground Clearance | 1.48ft in | 450mm |
|---|---|---|
| Length With Bucket On Ground | 23.09ft in | 7035mm |
| Width Over Tires | 8.01ft in | 2440mm |
| Height To Top Of Cab | 10.7ft in | 3260mm |
| Wheelbase | 9.52ft in | 2900mm |
| Hinge Pin - Max Height | 12.56ft in | 3828mm |
| Reach At Max Lift And Dump | 3.19ft in | 971mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.